Emanage Ultimate Wiring and Autosport Harness Install Questions
Thread Starter
Revs to 9K!!!
Joined: Feb 2006
Posts: 51
Likes: 0
From: At my House!
Emanage Ultimate Wiring and Autosport Harness Install Questions
Ok, I have a few questions about the installation of the autosport harness. I took the pcm cover off and was inspecting the compartment and it seems like it's going to be too much wire to put in there (especially after wiring the emanage up to it). Can anyone post pics of the wiring harness installed?
Guest
Posts: n/a
I cut the corner post of the pcm cooling jacket so it can slide forward and allow room for the extra wires:
I then took out the metal brackets that held the pcm in place and used some high temp foam to cushion/support it:
The pcm now fits with the wiring harness:
Another shot of the modified jacket with the pcm in place:
I also added a some foam under the lid to make sure the pcm is complely supported:
I ran the wires from the harness through the rubber seal on the back of the pcm case. I used a razor blade to cut out just enough to slide the wires through and then sealed it with up with some silicone. It's tight, but with a little massaging, you'll get it.
I then took out the metal brackets that held the pcm in place and used some high temp foam to cushion/support it:
The pcm now fits with the wiring harness:
Another shot of the modified jacket with the pcm in place:
I also added a some foam under the lid to make sure the pcm is complely supported:
I ran the wires from the harness through the rubber seal on the back of the pcm case. I used a razor blade to cut out just enough to slide the wires through and then sealed it with up with some silicone. It's tight, but with a little massaging, you'll get it.
Thread
Thread Starter
Forum
Replies
Last Post
{FS/WTT} 1992 Efini (Mazda) RX-7 JDM Type X
RXeckless
RX-8's For Sale/Wanted
6
Aug 16, 2015 12:51 PM
MolecularConcept
New Member Forum
15
Aug 5, 2015 04:43 PM
MolecularConcept
New Member Forum
2
Aug 1, 2015 03:15 PM
