STM Custom Aluminum Exhaust
#27
No respecter of malarkey
iTrader: (25)
The really funny part is that the first exhaust for the RX8 that I built back in 2005 using stainless steel along with an OE muffler pipe only weighed 9 lbs
https://www.rx8club.com/series-i-aft...e2/#post922293
https://www.rx8club.com/series-i-aft...e2/#post922293
#29
No respecter of malarkey
iTrader: (25)
it doesn't say aluminum, so pure speculation until someone verifies it
however, I've seen plenty that didn't including the previous link to an RX8 specific failure ...
If it never breaks you are good. If it breaks at the worse possible time you could be heavily inconvenienced or down-right screwed. If you think 3 lbs is worth aluminum over stainless steel for a cat back then more power to you. The problem in general is most people use too thick for SS (and/or wrong grade for the manifold/cat pipe) making it heavier than necessary. My entire SS exhaust system with manifold, cat, mufflers, & hangers is under 30 lbs total. The manifold was built in 2006 and is finally starting to give out despite being T321 material. The new manifold/header/whateveryouwannacallit that I hope to build soon will hopefully use Inconel 625 material for the primary tubes. That's the plan anyway.
however, I've seen plenty that didn't including the previous link to an RX8 specific failure ...
If it never breaks you are good. If it breaks at the worse possible time you could be heavily inconvenienced or down-right screwed. If you think 3 lbs is worth aluminum over stainless steel for a cat back then more power to you. The problem in general is most people use too thick for SS (and/or wrong grade for the manifold/cat pipe) making it heavier than necessary. My entire SS exhaust system with manifold, cat, mufflers, & hangers is under 30 lbs total. The manifold was built in 2006 and is finally starting to give out despite being T321 material. The new manifold/header/whateveryouwannacallit that I hope to build soon will hopefully use Inconel 625 material for the primary tubes. That's the plan anyway.
#30
No respecter of malarkey
iTrader: (25)
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM
arexatemate
RX-8 Parts For Sale/Wanted
6
10-28-2019 08:16 AM
fc2se
NE For Sale/Wanted
2
06-01-2016 08:55 PM