rx8 greddy turbo kit install starting problems
#28
An if I hve bad coil packs will that prevent it from starting as well cause imma chk that. An was is the easiest way to unflood it cause I tried pull starting it an dropping the clutch an that didn't work but I only tried once. Do I hve to do it a few times to really clear it out
#29
Modulated Moderator
iTrader: (3)
If you didn't touch the coils and it ran before the install...you likely flooded it...you might want to check and see if the eccentric shaft sensor is plugged in...and check that you have spark...but other than that you should be able to tow start it if all systems are working properly...just keep pulling it till it starts ( within reason )
#30
Where an what is the eccentric shaft sensor. An ya it was running before install so cool I should be good on that. Ya I'll have too keep tryin for sure to tow start it
#32
Asshole for hire
iTrader: (1)
Join Date: Jun 2006
Location: Colfontaine, Belgium
Posts: 3,214
Likes: 0
Received 3 Likes
on
3 Posts
http://foxed.ca/rx7manual/2003mazdarx8/
click: Engine/Control System - Eccentric Shaft Position Sensor Removal/Instillation
if its unplugged you will get no spark or fuel
click: Engine/Control System - Eccentric Shaft Position Sensor Removal/Instillation
if its unplugged you will get no spark or fuel
#38
Damn ok so basically If I get the car running I should drive for a little so it don't flood then turn it off an put the blue emanage in for now till I get a better comp so I can at least drive it around. Right?
#39
Asshole for hire
iTrader: (1)
Join Date: Jun 2006
Location: Colfontaine, Belgium
Posts: 3,214
Likes: 0
Received 3 Likes
on
3 Posts
if you get it running, just let it idle till its warm, safer than driving around to warm it up. Then get the emanage back in until you can get proper management setup. Even then i would be wary of pushing it on the equipped emanage maps
#44
Modulated Moderator
iTrader: (3)
I will try and remain civil a bit longer...but you need to do some reading in the forum
Detonation is deadly in a rotary engine......even one good ping can break a seal...so a bad tune is asking for it...
The emanage doesn't tune the RX-8 well...the stock out of the box tune in it is pathetic....so Boom is very possible..
You decide after a bit of reading if you want to push your luck...or find a relatively inexpensive way to make it run much better
PS: Do you have a WBO2 meter in the car......
IF NO.....park the car until you get your head straightened out
Detonation is deadly in a rotary engine......even one good ping can break a seal...so a bad tune is asking for it...
The emanage doesn't tune the RX-8 well...the stock out of the box tune in it is pathetic....so Boom is very possible..
You decide after a bit of reading if you want to push your luck...or find a relatively inexpensive way to make it run much better
PS: Do you have a WBO2 meter in the car......
IF NO.....park the car until you get your head straightened out
#45
Well imma keep it parked then. Ya thanks for that tip will the car be able to run better if I get the Cobb ap an then dyno the car an get it profesionally tuned or should I wait to get it tuned till I get the right accesseries so it don't blow up on the dyno with that shitty comp
#46
I zoom therefore I am.
1. get it running
2. get gauges that support putting a turbo in an RX8
3. get a better tuning solution, i would suggest the AP from mazdamaniac
4. tune it
5. profit.
2. get gauges that support putting a turbo in an RX8
3. get a better tuning solution, i would suggest the AP from mazdamaniac
4. tune it
5. profit.
#48
if you dont have a boost gauge dont try to do anythimg more than idle. Get the AP, you will need it eventually, put on MM base FI tune (that should give you a little insureance if you do go into any boost) and work on getting it running with that map on.
I wouldnt even touch it to get it running if you dont have any boost gauges or a tune.
I wouldnt even touch it to get it running if you dont have any boost gauges or a tune.
#49
im prolly gonna end up selling my kit there was a problem with the stock computer an i still have warrenty on my car an i have to take the kit off to still get the warrenty or else it will be void...so im selling my kit after i take it off i dont wanna put it back it on its to much of a hassal to go through all that again...if anyone wants it 2500$...pick up only i live in buffalo ny if your interested...post mail me at ringer60@aol.com...plus i cant afford all the gauges an the port an the tune right now...so any offers let me no