ric shaw ecu?
ok ill be home in a little while ill read through the manual .also i believe hymee has one installed in his car . and you can get a harness so you dont cut into your car ecu wires.
I am in contact with the maker of these units. Ric Shaw does not make them, and the maker told me he only ever sold 3 to Ric.
I am still planning on using this unit with the S/C.
I can't put you into contact with the man himself, as he will only deal with a distrubution network. Which could very well end up being me
Cheers,
Hymee.
I am still planning on using this unit with the S/C.
I can't put you into contact with the man himself, as he will only deal with a distrubution network. Which could very well end up being me

Cheers,
Hymee.
It does not have an on/off switch per se, but it is a simple matter (10 second job) to bypass the unit by unplugging it and connecting a bypass circuit to the harness.
I'll check up about the Nitrous...
Cheers,
Hymee.
I'll check up about the Nitrous...
Cheers,
Hymee.
Originally Posted by guitarjunkie28
i can't seem to find it online...
anyone know where i can read up about it and/or order one?
thanks
anyone know where i can read up about it and/or order one?
thanks
cool.
i've heard it mentioned, but what are its limitations?
is it just a piggy back that will allow you to add or subtract fuel and timing up to a percent, or can you build a fuel map from scratch?
i've heard it mentioned, but what are its limitations?
is it just a piggy back that will allow you to add or subtract fuel and timing up to a percent, or can you build a fuel map from scratch?
Originally Posted by Hymee
It does not have an on/off switch per se, but it is a simple matter (10 second job) to bypass the unit by unplugging it and connecting a bypass circuit to the harness.
I'll check up about the Nitrous...
Cheers,
Hymee.
I'll check up about the Nitrous...
Cheers,
Hymee.
thanks hymee , ok so i can wire a switch to inside the car to shut down the ecu
correct ???
Originally Posted by smrx8
thanks hymee , ok so i can wire a switch to inside the car to shut down the ecu
correct ???
correct ???

Unless you rigged up a hi-density switching gang...
What you do is unlpug the harness from the piggy back, and plug a blanking "plug" into the end of the piggy back cable, that hooks into the wiring loom. We made a loom for the RX8 so it plugs in without cutting any wires.
Unles Rad has updated his design for newer models, there is no switch per-se.
I should post some pics.
Cheers,
Hymee.
Thread
Thread Starter
Forum
Replies
Last Post



