RB Ram Air Intake Duct discussion
03-26-2006, 11:44 AM
#327
Registered
Join Date: Sep 2003
Location: Newport Beach, CA
Posts: 230
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 9K RPMS
...Import Tuner (April 06') .. product testing of ... the REVi intake and their Street Exhaust on the test Dyno..
Last edited by MPG > HP; 03-26-2006 at 11:45 AM. Reason: Added ?
03-26-2006, 02:09 PM
#329
Registered
Join Date: Sep 2003
Location: Newport Beach, CA
Posts: 230
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by TeamRX8
lol
03-26-2006, 03:25 PM
#330
try searching "revi mpg" (in this same thread even) and you might also try googling what it takes to generate 60 mph flow over thr front of a configured car, which is the only way to get an accurate measurement, I doubt they rented a wind tunnel just to make such a test
but fwiw, I didn't mean it as ridicule against you personally, just that it's only the 50th time I've seen someone ask the same mpg question ... thank you for asking rather than flying off the handle with a wayward assumption, not very common around here and worthy of respect
but fwiw, I didn't mean it as ridicule against you personally, just that it's only the 50th time I've seen someone ask the same mpg question ... thank you for asking rather than flying off the handle with a wayward assumption, not very common around here and worthy of respect
Last edited by TeamRX8; 03-26-2006 at 03:28 PM.
03-26-2006, 06:12 PM
#332
Momentum Keeps Me Going
It may provide it a bit cooler air, for whatever that does, but improve performance of the engine? ...not likely by enough to measure...the k&n is not a true sealed box like the REVi... amd even if it was...well read the previous post a few above. Improvements are REALLY hard to come by.
03-26-2006, 07:39 PM
#333
No they did not rent a wind tunnel for the test.
Though a wind tunnel would increase the effectiveness of the REVi you might only see another 3-4hp gain bringing the grand total to 10hp gain.
So far my total conclusion even if I am a total novice is that from what I have gleaned from my research, reading etc. is that the Mazda engineers did an exceptional job on the car.
Maybe a few lighter components, less airbags (even though they keep the insurance rates down). I personally would like to see a CF driveshaft for starters. Not that would be cheap but I think it would help decrease the hp loss between the flywheel and rear wheels.
Of course you could always go the route of the Turbo and Inter Cooler and fuel management system... CHA CHING! Not to mention a huge decrease in mpg which I know most of us are trying to avoid.
It's all a matter of personal opinion I think. To each their own and everyone love their ride in their own way.
Peace, Love and Wankel!
Though a wind tunnel would increase the effectiveness of the REVi you might only see another 3-4hp gain bringing the grand total to 10hp gain.
So far my total conclusion even if I am a total novice is that from what I have gleaned from my research, reading etc. is that the Mazda engineers did an exceptional job on the car.
Maybe a few lighter components, less airbags (even though they keep the insurance rates down). I personally would like to see a CF driveshaft for starters. Not that would be cheap but I think it would help decrease the hp loss between the flywheel and rear wheels.
Of course you could always go the route of the Turbo and Inter Cooler and fuel management system... CHA CHING! Not to mention a huge decrease in mpg which I know most of us are trying to avoid.
It's all a matter of personal opinion I think. To each their own and everyone love their ride in their own way.
Peace, Love and Wankel!
03-26-2006, 07:42 PM
#334
Momentum Keeps Me Going
Originally Posted by 9K RPMS
I personally would like to see a CF driveshaft for starters. Not that would be cheap but I think it would help decrease the hp loss between the flywheel and rear wheels.
Thread
Thread Starter
Forum
Replies
Last Post
