The logo on the REVi Intake take fell off today. To be fair, it was 98+ out today, and I was on the highway most of the day. Maybe the glue got dissolved from the heat?

this logo:








Has anyone else experienced this problem? I'm sure it can be super glued back on, but will that hold with all the heat?

any suggestions on what to do?>

 

Leave it off. Disco Stu don't advertise!
saves some weight too :p

 

I'm not advertising, but it completes the look imo. Plus there's an indentation where the logo would go...

 

I see. Just go to a local hardware store and browse the epoxies. I'm sure there is a heat resistant one.

 

You need to put rubbing alcohol on the plastic before you replace it.
RB is one of the best companies out there.
Why don't you give them a call. I'm sure you can get one for cheap!