Mishimoto aluminum fan shroud
#26
Registered
Update, headache went away and I found the thread I think lol https://www.google.com/url?sa=t&sour...9li3fzuYoWO--Z
#27
No respecter of malarkey
iTrader: (25)
Here too
https://www.rx8club.com/series-i-maj...5/#post4282994
a few posts below that one he talks about one of the Mizu fans dying already just before he got the FAL installed.
https://www.rx8club.com/series-i-maj...5/#post4282994
a few posts below that one he talks about one of the Mizu fans dying already just before he got the FAL installed.
Last edited by TeamRX8; 01-25-2020 at 07:29 PM.
#28
Registered
That threads a good read, i'd recommend anyone who reads this thread to pop over to that one after. Not sure if you'd know I haven't found this on any of these threads yet, the factory cooling fan amperage draw? The FAL 420's say they draw 22A on the summit racing website, i thought i saw the value 18A floating around I think that was in reference to stock but it was unclear. Worst case ill check em the hard way and throw an amp clamp on them while they're in high speed and update so anyone else has access to that spec
#30
Registered
It's Fused for 40 but it doesn't run at 40 regularly, either way we'll within the circuit breaker rating I've reached out to a local parts shop that carries FAL fans and I'm awaiting pricing will likely go this route however the Mishimoto shroud just looks nicer haha, Flex a lite fans are definitely better quality I've installed them on other vehicles before
Thread
Thread Starter
Forum
Replies
Last Post
Alupis
Series I Tech Garage
35
11-09-2015 09:21 AM
SARRAS
Series I Aftermarket Performance Modifications
2
04-25-2011 04:39 AM