are MAF pipes or MAF mounting bungs available?
#1
Registered
Thread Starter
are MAF pipes or MAF mounting bungs available?
I'm looking for a pod style air filter pipe with a MAF mount or just a weld on MAF bung. something like the Racing beat revi intake's blue metal MAF pipe but with out all the other hardware.
I could buy a K&N tornado kit or the revi but considering I would junk 90% of the kits the cost is to much.
anyone know of a store selling one?
I could buy a K&N tornado kit or the revi but considering I would junk 90% of the kits the cost is to much.
anyone know of a store selling one?
#3
Registered
Thread Starter
I'd like a hks one but it's about $500 for the rx-8 kit?
after another look the HKS one wouldn't work. I just need something like the greddy turbo kit one or I'll fabricate one.
after another look the HKS one wouldn't work. I just need something like the greddy turbo kit one or I'll fabricate one.
Last edited by rotarenvy; 01-28-2008 at 01:44 AM. Reason: more info
#4
more then a Mazda
Join Date: Jan 2005
Location: VIRGINIA
Posts: 509
Likes: 0
Received 0 Likes
on
0 Posts
depends on how crafty you are?believe it or not most pepboys auto stores carry the complete make it yourself kit piece by piece.tube ,air filter bends and or curves.
#8
No respecter of malarkey
iTrader: (25)
3.5" aluminum intake tubing and elbows are very common
http://vibrantperformance.com/catalo...c2af3ff1cf59c1
The MAF bung is a different story. You typically cut the tube off an OE housing or rob a MAF tube from another kit.
#20
Registered
Thread Starter
I'll also see if RP or RB will sell me one.
#21
Administrator
iTrader: (7)
they say you learn something every day...
#23
Administrator
iTrader: (7)
#24
I wrote to racing beat about their revi MAF housings, this is what I got back:
Yes, I have these units available. FYI, the ID is 3.44" and the OD is 3.6.
This component is produced from cast-aluminum, then machined to final
tolerances, then anodized. If you are interested, give us a call and ask for
PN 97212 - $47.50.
This component is produced from cast-aluminum, then machined to final
tolerances, then anodized. If you are interested, give us a call and ask for
PN 97212 - $47.50.