Greetings all,

A newbie here with a question.

I am using a Renesis engine in an aircraft and have designed a custom intake manifold, utilizing part of the original cast aluminum one.

I need to obtain injector bosses so that I can weld them into my outside intake tubes that will fit the renesis secondary injectors . (the primaries will be in the original locations.)

Does anybody have an Idea of where I can get these bosses that will capture the OEM injectors???, hopefully to allow me to feed them individually with an AN fitting. The ones that I have been able to find have "sockets" that are too large for the small O-rings used on the OEM injectors.

Thanks in advance,

Rich

 

Bump to help the guy out. Someone should know this!! Rotary on aircraft = epic!

 

Interesting... Bump as someone on here will/should know this....

 

Your doing what?

 

It's more common than you think to put a rotary in a single engine airplane.

Contact Atkins Rotary ((253)-848-7776)as Dan has ventured into the aviation side as well.

If that does not work I would imagine you can have them machined at a local shop pretty easily.

 

That pretty cool, actually. After my contract with the infantry expires, I think I'm gonna switch over to aircraft mech. Lots of useful info, there!

 

+1 for Atkins, very reputable.

You can also try to contact Richard Sohn @ http://www.rotaryaviation.com/, his products are top shelf and I'm sure he can help you out.

 

or any number of aftermarke fuel injection specialist companies, these are fairly common, but if you need help them PM or email me