{ FS } 2005 RX8 Koni Challenge Race Car for Sale
#1
2005 RX8 Koni Challenge Race Car for Sale
Year: 2005
Make: Mazda
Model: RX-8
Price: $24000
Mileage: 5000
Color: Orange and Red
Private or Dealer Listing: Private Listing
Location (US State/Canada/Int): CA
Built from new - The car is breathtaking
Please Note: we've reduced the price! We're asking $24,000.00.
General overview
- Originally built by Roar Racing for the Koni Challenge Series
- Re-race engineered by Joe Geldert, Crew Chief for Autocon Motorsports ALMS P1 and GT1 race cars, of Escondido, California (9 months ago)
- Revised engine and diff cooling fabrication and plumbing provided by Twin’s Turbo of Signal Hill, California (5 months ago)
Motor
- Engine built by: MAZMART (approximately 10 hours)
- AEM dry flow cold air intake
- Dual Setrab engine oil coolers
- Wix oil filter (remotely mounted)
- RC Engineering matched fuel injectors
- Moroso brand spark plug wires
- Speedsource Eccentric shaft and Alternator pullies
- Dynotuned header
- BRAND NEW 4 puck ACT clutch kit
- Resurfaced ACT flywheel
Electronics
- AMB transponder
- AIM MXL Pista gauge
Suspension
- Koni 2800 series shocks
- Eibach springs
- Racing Beat sway bars
Brakes
- Freshly rebuilt calipers
- New OEM front and rear rotors
- New Cobalt pads front and rear (Model #:XR1 Fronts, XR5 Rears)
- New OEM front and rear brake mounting hardware
- Goodridge brand stainless steel brake lines
Engine Cooling
- Custom Ron Davis Radiator
- Radiator Swirl Pot by Pete’s Speed and Fab
Differential Cooling
- New Setrab oil cooler with fan pack
- New Tilton brand Oil pump
- New Peterson brand in-line Oil filter
- Newly installed and plumbed
- NACA ducting and Plexiglas windows installed on the rear doors
- 3” cool air hose routed to oil cooler
- New 6” differential overflow tank
Chassis
- Freshly rebuilt differential with ’09 final drive ring and pinion (All new OEM Bearings, seals, crush sleeve, and pinion nut)
- New halfshafts
- Mazdaspeed Strut tower bar with built in brake master cylinder brace
- Axia flow short shift lever
- Fresh OEM rear suspension hardware
- Fresh OEM driveshaft hardware
- New OEM ball joint boots
- ARP wheel studs
- Racing Hart wheels (17x8) (1 set)
Driver Safety
- Peter Gilbreath (Pete’s Speed and Fab) built roll cage
- Sparco driver seat (Evo L)
- Sparco passenger seat (Evo L)
- Brand new Safecraft driver’s side belts
- Sparco passenger side belts
- Window and Safecraft inboard intermediate nets
- Sparco steering wheel and quick release hub (Weld on)
- On-board fire suppression system - Safecraft
Paperwork
- Orignal vehicle registration paperwork
- Tons of set up notes from the team owner and crew
- OEM factory shop manuals
RX8 spares package
- Four sets of NEW Colbalt racing pads – rear (model XR5)
- One set of NEW Colbalt racing pads – front (model XR1)
- Rebuilt transmission (’04-’08)
- Engine – short block
- Lower Intake manifold
- Speedsource pulley set (E-shaft, Alt., and OEM water Pump)
- ACT Flywheel
- Set of half-shafts
- New rear caliper
- Set of front aluminum A-arms (Upper and Lower)
- Set of rear control links
- Safecraft fire bottle (Full charge)
- New OEM water pump and gaskets
- 1 ½ sets of matched fuel injectors (RC Engineering)
- New OEM brake master cylinder
- New OEM clutch master cylinder
- Set of ARP wheel studs
- AiM Beacon
- Goodridge steel brake line set (new in the box)
- (2) AiM temp sensors
- Check valve
- Misc. electronic connectors
- (2) oil pressure sensors
- (2) new rear wheel brake harnesses for the ABS system
- Hood (OEM Aluminum)
- Set of front fenders
- Set of rear door ¼ glass
- Chassis wire harness (minus engine harness and trunk harness)
NOTE: We literally have hundreds of photos of our race car that we can share. Please e-mail with any questions. Please provide your e-mail if requesting photos. I'd love to post photos but I can't figure out how to on this site....
Report Post Page 1 of 1
Last edited by Eric Rosenberg; 08-29-2012 at 09:29 AM.
#2
Price reduction
Just wanted to let everyone know that we've reduced the price of our race car. We're taking $1,500 off the asking price so the asking price is down to only $24,000!
Please check out the ad and let me know if you have any additional quesitons.
Thank you,
Eric
Please check out the ad and let me know if you have any additional quesitons.
Thank you,
Eric
Thread
Thread Starter
Forum
Replies
Last Post