Nice!

I do know that feeling, rising temps normally cost me a second, or even two. I don't always use my fastest lap as a reference for next time.

 

1:25.2 at Streets of Willow Springs

 

Holy sh*t. Mod list? I'm gonna update the original post.

 

This is primarily a SCCA STX car but I'm just having fun at the track while the weather is cold waiting for the Pro Solo season to kick off again

2004 Base Sport
2,790 lbs with 1/4 tank

Some motor I found out of some drift kid's car, leaks oil, decent compression
Sakebomb IGN-1A Coils
Off the shelf Versatuner tune
Stock Intake with K&N panel, some heat shielding.
Modified Alibaba header
TurboXS catted midpipe. (Catless for track)
3" From collector to exit, Racing Beat exhaust. All V-band.
Ron Davis Radiator
BHR Motor Mounts
SuperPro diff bushings
Kaaz 1.5 diff

255 Yokohama A052 on 17x10 Konig Hypergrams
Penske 7500da by Ankeny Racing Enterprises
560f
450r
Diftech front upper mounts, Diftech 350z bearings on stock rear mounts.
MazdaMotorsports Bar, .250 wall
Racing Beat NC Rear bar.
Mazda Motorsports offset delrin front upper control arm bushings
Diftech offset knuckle bushings
Rear bushings SuperPro
Front lower is stock.
-4 f, 0 toe
-3.5 r, 3/16 toe in

 

Thank you! All results since 2017 added to the main post. Sorry about that, hard to believe it's been almost 2 years since the last update. I haven't run at all this year, so live vicariously through your posts.

 

Use to run street willow a lot when I still live in state, Miss it !!

 

ZOMG, your rear spring rate is too high compared to the front rate!!!!

 

Wow, great driving, car prep and video overlay! What software are you using for that?

 

Looks like I never shared my SoW CCW time from last year. That was my first (and so far only) time there and had a blast.

Streets of Willow CCW - 1:27.64 -- blu3dragon -- RX-8 S1, estimated at 185rwhp and 3000lbs w/driver. S2 transmission & Diff. Race seat, harness & roll bar. APR wing & DIY splitter, Fatcat coilovers, Toyo RA1 255/40/17 tires (previously used as wets).


Now that I've seen RE-Vision's lap,I need more practice, more camber, and maybe CW is faster? :-D

 

yes my setup doesn't work at all i've been told by many people

 

CCW is supposed to be faster. We'll see, I'm going to do that config next month.

 

well I’d make a few different choices and cut another 80 lbs off, but overall am fairly impressed with your car. Definitely put you up in the upper elite category as far as STX RX8s that I’ve seen over the years. That’s about a handful or so.

 

NCM Motorsports Park 2:20.2
Putnam Park 1:16.4

315 Yokohama A052 on all four, a bit over 2600lbs

Car is built for SCCA Time Trial series.

 

Car is built for SCCA Time Trials
~2700lb
stock motor, lot of custom bits otherwise.
Pulls a lot of G in high speed corners
315 square Yokohama A052

NCM 2:20.2
SCCA Max3 class track record, won at nationals 2019

The car in the same configuration also ran at
Putnam Park 1:16.4

Next year will likely drop a few more lbs and run Hoosiers for unlimited 2.

 

Oh, nice!

 

Hit Buttonwillow CW13 this weekend. First time at this track in 4 or 5 years and the last time was just one lap in my Elantra, safe to say it's basically new to me. Got a 2:02.3, lots of little and one very big mistake to fix next time, pretty sure 2 flat or faster is achievable.

 

2:04.09 at Chuckwalla CW on Saturday. Will upload video when I can.

 

was in town for 10 days. took RX-8 i bought 2 years ago to drive at street of willow
I think i did ok 1:29.8 desptite using 6 years old Champrio GT that come with car

 

nice!

 

Thanks , ur lap time is very fast
How wide of A052 u are using

 

255/40/17

 

Here is a 1:38.1 at Gingerman
Stock engine. 315 A7s. Lot of downforce and weight reduction.

 

that’s smokin’ compared to the other times posted for there

gotta watch those rev limiter hits though edit: maybe you’re on the gas still when the clutch pedal is going in instead?

 

have you measured tires temps with a pyrometer? i feel like 315 width hoosiers would take a while to get to temp.

 

that’s a good thing with the A7 compound, downforce and those cornering speeds are going to warm them right up imo