Disconnecting 0BD2 Port-Wiring From The Dash
#1
Registered
Thread Starter
Disconnecting 0BD2 Port-Wiring From The Dash
Its the only thing holding the dash on at the moment, so is it a case of pinging the wires of with a tool from the driver seat or am I looking for something behind the dash to disconnect the port as I cant see anything. Very tight behind there just to even get your hand in. Just trying not to break anything and do it right.
Please and thanks.
Regards Aidan
Please and thanks.
Regards Aidan
The following users liked this post:
Aido 8 (09-03-2018)
#6
Registered
Thread Starter
So its dangling there after prying it out from the centre passenger side but I want it to come out inside the dash so the dash would just fall down so what now
#7
Registered
Thread Starter
Ok I was convinced if I tried to force this out sideways up through the dash I would take a chunk out of the dash or the port but thank god its out cleanly and no sign of debri phew!!
Thread
Thread Starter
Forum
Replies
Last Post
AZ R3
Series II Interior, Audio, and Electronics
3
05-31-2012 04:12 PM