I have two extra ***** sitting here... one I tried to make a homemade illumination ****... and on the other the bottom part like fell out... it's useless... but it has the top in good condition. I found that there is a screw under the little clear plastic part with the shift diagram (1,2,3, etc). It is glued in there... so how can I get it out while keeping it intact and looking good?

Heat? Cold? ideas?

 

no clue, check DIY sections cause I know ppl have changed them.

 

mine is loose that's all I know

 

The little clear plastic part is? Because Under that is the screw to get the rotary symbol off... and thats what I want.