Hi everyone,Im looking to get a project up and going i have purchased a 323 rear wheel rolling chassis and would like to do a build but would like to know where to start as I only have access to rx 8 motors and would like to fit it to the car.Is here anyone that can advise me on what i will need to convert it to carb etc? And get the build done properly

 

I can't comment on how to convert it to a carbutetor, but I have to ask why that's the project? It's a lot of work to make half the power a properly managed renesis makes. I'd suggest instead retrofitting fuel injection and electronics into the 323.

 

Is it possible to do a build like that into a 323 or would you reccomend staying with the fuel injection and running ecu on the build.