Cooler lines
#1
aka wingman
Thread Starter
Join Date: May 2006
Location: NEW HAMPSHIRE
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Cooler lines
Looking for some insight on a/m oil cooler lines for my 2004 rx8..w/mtm..the factory lines are leaking like a siv and they're big bucks threw mazda for oem..Wut would anyone recommend for a/m..Heard the racing beat lines are pretty nice..needs some advice and help..thanks all
#5
whines all the way home
iTrader: (2)
Join Date: Oct 2004
Location: Towson/Baltimore, MD
Posts: 7,402
Likes: 0
Received 2 Likes
on
2 Posts
I installed the Racing Beat kit on mine, it was a pain in the *** but such a better setup. The fittings arent the best, after about a week I developed a small leak at the actual inlet end of the first(drivers side) cooler, took it off, the fitting had actually cut into the hose. I lukily had a couple extra AN fittings laying around from my remote oil filter setup, replaced it and havent had any issues from that point on,,,
Also the kit may seem pricey for three braided lines but its around a third of the cost of the lines that are sold as oem parts from Mazda,,,
Also the kit may seem pricey for three braided lines but its around a third of the cost of the lines that are sold as oem parts from Mazda,,,
#6
Hermitage Holdout
Since your also apparently a NH based 8, you could also try this approach https://www.rx8club.com/series-i-trouble-shooting-95/rusted-oil-cooler-fittings-183281/.
Thread
Thread Starter
Forum
Replies
Last Post
TotalAutoPerformance
Vendor Classifieds
12
10-17-2018 09:00 AM