Hi guys,

I just installed the rotary start button on my car, was wondering if my setup was correct since the installation manual is in Japanese.

Once the button is press and the engine is started, is it suppose to be disable or it will still allow the engine to crank when the button is press again. Please kindly advice. Many thanks.

 

Hi! U right - once button is pressed, engine starts. Light on button goes off & button goes 'dead' (i.e. nothing happens if u press it).

And whatever u do... enjoy the button!!! Cheers!

 

Err... u still need the key to be inserted and turned b4 pressing the button, rite?

 

yup..it brin the 'twist' action to 'press' action...the ign still must b turn-on & steerin lock gotta b released too.

 

Bro, thanks for the info.

 

BlackAero, thanks for your info on cartronics at AMK. Met u last saturday at rangoon road. Went to purchase some accessories.. very EX awaiting for shipment

 

hello,

may i know where did you get this start button and where to install? thanks!

 

U can get it from most (all?) PIs.

As for installation, u can try diy; or ask the PI to help wire. Good luck!

P.S. If u get the auto remote start fited; pls let me know!!!

 

Start button cost around $300plus, got thru PI plus installation. Or you can try the vendors section and purchase over the net.

 

thanks! but i am not good at diy,
and how much is per set?

 

I'll check around & let u know.

Better yet, show up for the meet this Sunday! Me sure some of the guys can help advise u. Me quite good at diy - but the quality is somehow (always) suspect... I've even set me car on fire before!

 

Hi M-ster! Didn't see ur post. Funny how it didn't show earlier... Don't think Shirube saw it either...

Yo Shirube! M-ster said it's S$300+ plus installation. Good deal!

 

Hummm...
that's weird???
I did post after your last 2nd post. Don't know why it jump the queue and went a head??
By the way plus installation was because I got the car from the PI, if one goes in just to purchase the button or anything for matter, chances are they will charge a fee.

 

Hey guys....will the start button work on a US 8?

- Danny

 

hi i think it should work for the US specs, as the proper imports here are from US.

 

Actually, i've not heard anything about them making the button for LHD yet. If remembered correctly, for RHD it's quite a easy plug and play thing, whereas for LHD the wires ain't long enough, thus more works are needed inorder to install the button.

 

FYI. I doubt it will work, as indicate in Japanparts site.

START BUTTON KIT
**RHD Unit only**Exchanging the coin case beside(RHS in Japan) the streeing wheel.
1st, you turn the ignition key on and the trim of that kit lights up. 2nd, putting the clutch plate and brake plate on. 3rd, pushing the button and engine starts working.