Help With MAF O Ring
02-26-2009, 05:56 AM
#1
I don't buy Kool-Aid
Thread Starter
Help With MAF O Ring
Yeah, brake spray will clean it up.
Lift straight up, don't damage the little "o" ring around the edge.
The brown bulb you see is NOT the MAF, just the temp sensor - spray up into the plastic body, the tiny wires up there are the actual air flow sensor, only a tiny proportion of the air goes over it, and the computer works out the flow.
S
Lift straight up, don't damage the little "o" ring around the edge.
The brown bulb you see is NOT the MAF, just the temp sensor - spray up into the plastic body, the tiny wires up there are the actual air flow sensor, only a tiny proportion of the air goes over it, and the computer works out the flow.
S
So should I put it back? or get a new one?
If I need a new one where can I get one?
What happends if I dont replace it?
WELP!!!
Well like StealthTL said; "Dont damage the little o ring"
So now what?
Thanks a bunch!
-Gil
02-26-2009, 09:38 AM
#2
are you talking about the O ring that seals the MAF to the Tube ?
if yes then, just replace it with a new one, its there to seal dirt from going into the intake (vacuum leak)
Is this the one u talking about ?
if yes. the part number is ZL01-13-214, its not a cheap part consider its just a god damn rubber ring, but u gotta pay to play
if yes then, just replace it with a new one, its there to seal dirt from going into the intake (vacuum leak)
Is this the one u talking about ?
if yes. the part number is ZL01-13-214, its not a cheap part consider its just a god damn rubber ring, but u gotta pay to play
Last edited by nycgps; 02-26-2009 at 09:44 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Shankapotamus3
Series I Trouble Shooting
28
03-14-2021 03:53 PM
Evan Gray
Series I Trouble Shooting
0
09-26-2015 12:30 PM
