New member from Wanganui
#1
Registered
Thread Starter
New member from Wanganui
Finally can post! Was a long 30days. So who have we got here from round Taranaki, Manawatu, Welly areas? Need to organise a cruise at some point. Although im just in the process of getting my motor out and rebuilt as it cooked itself heading to Powercruise the other weekend
#3
Finally can post! Was a long 30days. So who have we got here from round Taranaki, Manawatu, Welly areas? Need to organise a cruise at some point. Although im just in the process of getting my motor out and rebuilt as it cooked itself heading to Powercruise the other weekend
welly \o/ prolly gonna go for a blat to wanga's in may/june
#4
Registered
Thread Starter
#6
Registered
Thread Starter
Well we think at the moment its water seals as when under load on the open road in top gear the cooling system is pressurizing and blowing all the water out the overflow. It got so hot that the water turned to steam haha. So i will be pulling the motor out next weekend and dropping it to the boys at PPRE to strip it down and see what im in for. Hopefully the housings are still sweet as they are the expensive part of the build aye. If the housings are sweet it could be a straight forward build only needing water seals and o-ring kit
#7
Boosted Kiwi
iTrader: (2)
Well we think at the moment its water seals as when under load on the open road in top gear the cooling system is pressurizing and blowing all the water out the overflow. It got so hot that the water turned to steam haha. So i will be pulling the motor out next weekend and dropping it to the boys at PPRE to strip it down and see what im in for. Hopefully the housings are still sweet as they are the expensive part of the build aye. If the housings are sweet it could be a straight forward build only needing water seals and o-ring kit
#8
Registered
Thread Starter
#9
Well we think at the moment its water seals as when under load on the open road in top gear the cooling system is pressurizing and blowing all the water out the overflow. It got so hot that the water turned to steam haha. So i will be pulling the motor out next weekend and dropping it to the boys at PPRE to strip it down and see what im in for. Hopefully the housings are still sweet as they are the expensive part of the build aye. If the housings are sweet it could be a straight forward build only needing water seals and o-ring kit
I hope its not that bad you need to spend the best part of 7.6-8g on it..
keep us informed.
Thread
Thread Starter
Forum
Replies
Last Post