New member from Wanganui
Finally can post! Was a long 30days. So who have we got here from round Taranaki, Manawatu, Welly areas? Need to organise a cruise at some point. Although im just in the process of getting my motor out and rebuilt as it cooked itself heading to Powercruise the other weekend
|
Got one from Feilding here a cruise sounds good theres a few guys from welly on here
|
Originally Posted by ROT8NG
(Post 4549637)
Finally can post! Was a long 30days. So who have we got here from round Taranaki, Manawatu, Welly areas? Need to organise a cruise at some point. Although im just in the process of getting my motor out and rebuilt as it cooked itself heading to Powercruise the other weekend
welly \o/ prolly gonna go for a blat to wanga's in may/june |
Originally Posted by Oggie
(Post 4564786)
welly \o/ prolly gonna go for a blat to wanga's in may/june
|
Originally Posted by ROT8NG
(Post 4565030)
Mean! Hit me up. My motor should be rebuilt by then too
lemme know what the cost was etc... and what they did to the rebuild.. regards Terry |
Originally Posted by Oggie
(Post 4565080)
lemme know what the cost was etc... and what they did to the rebuild..
regards Terry |
Originally Posted by ROT8NG
(Post 4566217)
Well we think at the moment its water seals as when under load on the open road in top gear the cooling system is pressurizing and blowing all the water out the overflow. It got so hot that the water turned to steam haha. So i will be pulling the motor out next weekend and dropping it to the boys at PPRE to strip it down and see what im in for. Hopefully the housings are still sweet as they are the expensive part of the build aye. If the housings are sweet it could be a straight forward build only needing water seals and o-ring kit
|
Originally Posted by Brettus
(Post 4566239)
Oh bugger ! Good luck ! You are lucky having PPRE in the same town !
|
Originally Posted by ROT8NG
(Post 4566217)
Well we think at the moment its water seals as when under load on the open road in top gear the cooling system is pressurizing and blowing all the water out the overflow. It got so hot that the water turned to steam haha. So i will be pulling the motor out next weekend and dropping it to the boys at PPRE to strip it down and see what im in for. Hopefully the housings are still sweet as they are the expensive part of the build aye. If the housings are sweet it could be a straight forward build only needing water seals and o-ring kit
I hope its not that bad you need to spend the best part of 7.6-8g on it.. keep us informed. |
Bit late to the party here but I am from Palmy.
|
Originally Posted by WRCfan
(Post 4590615)
Bit late to the party here but I am from Palmy.
there is a palmy in japan???? oh yes palmy or palmy north? |
All times are GMT -5. The time now is 06:05 PM. |
© 2024 MH Sub I, LLC dba Internet Brands