Yea here they are PIAA 19X9 and 19X10 in the back.
http://www.piaa.com/Wheels/Wheel_Rozza.html

 

Better make sure they fit. I have 19" x 9.5" in the back with a 35 mm offset and it is already right at the edge. The catalog says 19" x 10" is a 25 mm offset. That would make the car look like a low riding hooptie.

 

I found these a long time ago, just can't afford them :D

 

Very nice!!

 

I just saw those same rims on an Acura TL a little while ago. They are sick! How much will those puppies set you back?

 

Yeah, great looking wheels. They're what I've been planning on if I decide to go the expensive route.

 

http://acostamotorsports.com/index.p...nails&album=11

Same ones on the acosta RX8. Same size to.

 

my Work 3 piece VS-SS are nicer..... PIAA is a copy cat YO :D jk

 

I dont know yet I call PIAA in the state of OR and the CSR rep gave me a phone number to call in SO-CAL but they where not open when I called. I would say over 3,K.:D

 

They better not. $500-$600 is the going price depending on the size you buy. And you can probably do a little better than that if you pushed hard enough. Even if you paid full retail they should only be about $2500 for the set.

 

heavy, but they look good.

 

For 19s, not that heavy. The 19x9.5s are only 24.8lbs.

 

Yea not bad prob is they will not fit! I called and the rep told me they will rub if I get 19's but I can get 18X9 & 18X10 ",