RX8 Clunking/Clicking Noise After Rebuild
RX8 Clunking/Clicking/Knocking Noise After Rebuild
Hi all,
I have just had my engine rebuilt and I have noticed there is this strange clunking/ticking noise noticeable at lower speeds now. Any idea what could cause it? It does not happen when I am stationary nor does it occur more when I rev the engine.
When I close the windows it seems to coming from the centre of the car but really hard to pinpoint exactly where it is
Please see the video below for an idea of what I am experiencing. In the video I am going about 15/20 MPH in second gear.
Car Specs: 231, 6 speed manual, 2006
Thanks!
I have just had my engine rebuilt and I have noticed there is this strange clunking/ticking noise noticeable at lower speeds now. Any idea what could cause it? It does not happen when I am stationary nor does it occur more when I rev the engine.
When I close the windows it seems to coming from the centre of the car but really hard to pinpoint exactly where it is
Please see the video below for an idea of what I am experiencing. In the video I am going about 15/20 MPH in second gear.
Car Specs: 231, 6 speed manual, 2006
Thanks!
Last edited by Ianky_giraffe; Jul 18, 2021 at 03:49 PM.
Does the frequency vary with speed? It sounds in time with your wheel rotation, which means something is rubbing around the wheels. Could be trivial like rust on your brake rotors or slightly bent brake heat shield.
Get the car in the air and try to turn the wheels by hand to see if you can recreate the sound.
If it varies with engine rpm then I'd worry more.
Get the car in the air and try to turn the wheels by hand to see if you can recreate the sound.
If it varies with engine rpm then I'd worry more.
Thanks for the quick response Loki! Yeah it definitely seems tied to the wheel rotation and still makes the sound if I press in the clutch. Ok cool I'll jack up the front tomorrow and see if I can recreate it. Only thing is it doesn't happen immediately, like I don't hear it when I pull off the drive but will when I slow down on the road 30 seconds later. Again though thanks for the advice and will report back soon!
Edit: Forgot to actually answer your question, yeah the frequency does vary with speed
Edit: Forgot to actually answer your question, yeah the frequency does vary with speed
Last edited by Ianky_giraffe; Jul 18, 2021 at 04:08 PM.
So I got the front end on some jack stands this evening and could not recreate the sound, or anything remotely similar. There didn't seem to be anything obvious that the wheel would be rubbing against either :/ I tried doing a couple of the tests for a worn wheel bearing but both sides seemed ok (in my unexperienced opinion). The lug nuts seemed pretty tight to get the wheels off but i've put them back on now and torqued them up so will give it another drive tomorrow and see if anything has changed. Almost certainly just going to need to take it back to the mechanics who did the rebuild and get them to investigate. I have had such rotten luck with this car over the past year but i'm far too emotionally invested in it now haha
Weirdly though when I spun the front right wheel with a decent amount of speed there was this ticking noise (completely different to the one in the video), it sounded electrical. No idea if that's related but just thought it was an interesting observation.
Weirdly though when I spun the front right wheel with a decent amount of speed there was this ticking noise (completely different to the one in the video), it sounded electrical. No idea if that's related but just thought it was an interesting observation.
Thread
Thread Starter
Forum
Replies
Last Post
TeenMike91
Series I Trouble Shooting
15
Mar 22, 2012 12:56 PM
Remington
Series I Trouble Shooting
0
Jun 25, 2011 02:11 PM



