Notices
Series I Trouble Shooting This is the place to learn more about or discuss any issues you're having with your RX-8

table saw noise

Thread Tools
 
Rate Thread
 
Old May 3, 2012 | 08:37 AM
  #2  
fuztupnz's Avatar
Phone Booth'd
iTrader: (4)
 
Joined: May 2009
Posts: 2,441
Likes: 1
From: Cincinnasty
It's the airpump.

Turns on during cold start up to blow air into the exhaust to warm up the cat quicker.

It's normal.

You've been on this board for 4 years? Have you never read a sticky?
Reply
Old May 3, 2012 | 10:28 AM
  #4  
fuztupnz's Avatar
Phone Booth'd
iTrader: (4)
 
Joined: May 2009
Posts: 2,441
Likes: 1
From: Cincinnasty
stickies are the threads at the top of each section that say "Sticky"
Reply
Old May 3, 2012 | 07:06 PM
  #6  
tcole6's Avatar
Registered
 
Joined: Apr 2010
Posts: 316
Likes: 0
From: NJ
I think your just more attuned to it so you notice it more. Can't imagine it's anything to worry about.
Reply
Old May 3, 2012 | 07:09 PM
  #7  
fuztupnz's Avatar
Phone Booth'd
iTrader: (4)
 
Joined: May 2009
Posts: 2,441
Likes: 1
From: Cincinnasty
Originally Posted by sfsoldier14
Just saw that. Mayne its just cause im on my phone but they seem to change every time i load the page. Should i be worried if it seems like its getting louder then before? I saw in another thread you can just remove it if you dont have a cat or emissions standard...i have both so no go there.
They will eventually go bad/wear out. That is likely what's happening with yours. Mazmart is a good place to get another, or the FS section of the forum.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mane
New Member Forum
2
Nov 20, 2015 12:16 PM
nowakm99
Series II Technical and Trouble shooting
1
Oct 9, 2015 07:10 AM
tommy26Germany
Series I Trouble Shooting
11
Sep 29, 2015 10:33 AM
Jb4ker96
Series I Trouble Shooting
0
Sep 27, 2015 10:06 PM
neoksk
RX-8 Parts For Sale/Wanted
3
Sep 21, 2015 12:31 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 05:06 PM.