Part ID
Smoking turbo yay
Joined: Apr 2017
Posts: 3,119
Likes: 674
From: BC, Canada
That's the cooling fan control kit from RX8Performance, or something similar to it.
Basically, it keeps the coolant temperature lower by telling the fan to come on earlier. IIRC it keeps the coolant temp below 90 C instead of the factory 98 C.
Basically, it keeps the coolant temperature lower by telling the fan to come on earlier. IIRC it keeps the coolant temp below 90 C instead of the factory 98 C.
Thread Starter
Registered
Joined: Sep 2018
Posts: 250
Likes: 7
From: Down Under
I'm just wondering if it's working properly. My S1 fans are louder than the S2 fans after engine is switched off when hot. I was parked for 5 minutes today with engine running in 107f 42c heat and temp gauge went over half way
Thread Starter
Registered
Joined: Sep 2018
Posts: 250
Likes: 7
From: Down Under
Thread Starter
Registered
Joined: Sep 2018
Posts: 250
Likes: 7
From: Down Under
Ok cooling fan comes on when cold and stays on all the time . Checked up to operating temp. Maybe whoever did the mod didn't do it right ? So maybe just one fan is working hence it went over half when idling today ?
Sounds like they might have forced fan 1 to operate all the time. Hard to conclude without being near the car, but faced with such a situation, I'd disconnect any wiring associated with this mod and restore stock functionality. If you still have heating problems then we can diagnose from there.
What am I doing here?
Joined: Mar 2006
Posts: 3,606
Likes: 652
From: 2017 Miata RF Launch Edition
Sounds like they might have forced fan 1 to operate all the time. Hard to conclude without being near the car, but faced with such a situation, I'd disconnect any wiring associated with this mod and restore stock functionality. If you still have heating problems then we can diagnose from there.
Thread Starter
Registered
Joined: Sep 2018
Posts: 250
Likes: 7
From: Down Under
Smoking turbo yay
Joined: Apr 2017
Posts: 3,119
Likes: 674
From: BC, Canada
This the correct stock setup. The extra relay in the green circle is for the optional seat heaters, and I wouldn't be surprised if Australian cars don't come with them.
The previous owner set it up wrong, BTW. The instructions say that you need to replace fan relay 1 and 2 with the provided units, except the kit is designed for S1, and while it works for S2, fan relay 2 in S1 is called fan relay 3 in S2 and vice versa, so you need to pull out fan relay 3 on an S2 and replace it with the relay in the kit. If you wish to use the kit, the two relays in the red circle are the ones you use.
I also included a picture of the relay for fan relay 2. It's a different unit compared to relay 1 and 3.
The previous owner set it up wrong, BTW. The instructions say that you need to replace fan relay 1 and 2 with the provided units, except the kit is designed for S1, and while it works for S2, fan relay 2 in S1 is called fan relay 3 in S2 and vice versa, so you need to pull out fan relay 3 on an S2 and replace it with the relay in the kit. If you wish to use the kit, the two relays in the red circle are the ones you use.
I also included a picture of the relay for fan relay 2. It's a different unit compared to relay 1 and 3.
Thread Starter
Registered
Joined: Sep 2018
Posts: 250
Likes: 7
From: Down Under
Yes I just replaced far right one with the correct blue one and no difference still
please do me a favour and see if your fan comes on with ignition and stays on when started
please do me a favour and see if your fan comes on with ignition and stays on when started
Last edited by Sydo; Jan 20, 2019 at 05:06 PM.
Water Foul
Joined: May 2013
Posts: 2,521
Likes: 266
From: Republic of Texas
Thread
Thread Starter
Forum
Replies
Last Post
