Ignition map
#1
Registered
Thread Starter
Ignition map
Was wondering if anyone had a map for the stock or even a tuned ignition timing table? I'm running an S2 motor in Lotus 7 replica running a Megasquirt ECU. Right now I'm using a map for a 2nd gen RX-7. It starts and drives around the block but I'm sure isn't ideal. I'm not really sure what this motor likes for timing and would rather not blow it up trying to find out. Thanks!
#2
This is a reasonably aggressive timing map off my S2. You'll need to figure out what load translates to on the Megasquirt though, so be really careful... I've linked a log in 3rd gear to give a little bit of context to what I see at full throttle.
https://drive.google.com/file/d/185S...ew?usp=sharing
https://drive.google.com/file/d/185S...ew?usp=sharing
#3
Registered
Thread Starter
Awesome! thank you. My first guess is the load is in Bar with a few cells on the positive side for good measure? Maybe having the intake pull from in front the radiator might pressurize the intake a small amount.
The following users liked this post:
DocWalt (11-02-2021)
#5
My intake does pull from in front of the radiator, as does stock. technically :P
The following users liked this post:
wcs (11-02-2021)
Thread
Thread Starter
Forum
Replies
Last Post
thewird
Series I Engine Tuning Forum
0
09-04-2009 07:31 PM