spring install -any snags that I should know about?
#1
Registered User
Thread Starter
Join Date: Nov 2004
Location: Earth
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
spring install -any snags that I should know about?
Im going to install my Eibach ProKit this weekend. Is there anything out of the ordinary I should know before doing this?
Thanks guys! I may take pics for a FAQ if I can find a cheapie digi cam. My 20D will not get close to grease
Thanks guys! I may take pics for a FAQ if I can find a cheapie digi cam. My 20D will not get close to grease
#3
Registered User
Thread Starter
Join Date: Nov 2004
Location: Earth
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Ok cool. Excuse my ignorance, but what exactly do you mean by pre load.
Thanks!
Thanks!
Originally Posted by Im_DANomite
the fronts are cake. the rear, just remember to mark the camber bolts. you have to remove the lower control arm and disconnect the sway bar end links. and when you tighten up the front control arms, make sure you pre-load. good luck.
#4
He's as bad as Can
Pre-load the springs with weight on them.
Lower the car BEFORE you tighten the control arm bolts.
FYI: https://www.rx8club.com/series-i-do-yourself-forum-73/diy-lowering-springs-install-23403/
Lower the car BEFORE you tighten the control arm bolts.
FYI: https://www.rx8club.com/series-i-do-yourself-forum-73/diy-lowering-springs-install-23403/
#7
Registered User
Thread Starter
Join Date: Nov 2004
Location: Earth
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
That was a lot easier than I had expected! I love the (mild) drop and it rides as comfortable as stock. In a week I will have it aligned, and be done with it. Pics after the MS bumper and Legamax are installed ;-)
(waiting on the brown truck)
(waiting on the brown truck)
Thread
Thread Starter
Forum
Replies
Last Post