Is This Bad?????
#1
Post Giggalo
Thread Starter
Join Date: Oct 2004
Location: San Antonio, Tx
Posts: 476
Likes: 0
Received 0 Likes
on
0 Posts
Is This Bad?????
Ok i just got the Tein S techs installed yesterday. And I think we forgot to pre load them. I think we tightened everything while it was still on the lift. I drove it home and all felt fine. Will this cause any problems? Can i still fix it???
#2
Registered User
Join Date: Jan 2005
Location: Visalia, CA
Posts: 522
Likes: 0
Received 0 Likes
on
0 Posts
Puts extra load on the bushings I believe, it's bad because it doesn't allow them to move as freely and it will wear them out a lot faster.
Just jack it up, losen them, then put it back on the ground and tighten them to specified range again.
Just jack it up, losen them, then put it back on the ground and tighten them to specified range again.
Thread
Thread Starter
Forum
Replies
Last Post
Shankapotamus3
Series I Trouble Shooting
28
03-14-2021 03:53 PM
duworm
Series I Wheels, Tires, Brakes & Suspension
1
10-01-2015 04:57 PM
Tgiolitto100
RX-8's For Sale/Wanted
1
09-29-2015 10:52 AM