Aggressive Wheel Fitment Thread
#2684
Registered
Join Date: May 2009
Location: Los Angeles
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
#2686
another broken syncro
Join Date: Jun 2008
Location: Mansfield, TX
Posts: 644
Likes: 0
Received 0 Likes
on
0 Posts
#2687
The Angry Wheelchair
iTrader: (14)
Jew, is that your car in the pic aka Brian? I got 255/40's but wondering depending how low I go if they're going to rub in the front wheel well when turning or not which rolling can't help. It looks close now with the stockies lowered so with a 255 I wonder if you had any issue with them. What height are you at from fender to ground on front and rear, or if you prefer, fender to wheel center?
#2688
another broken syncro
Join Date: Jun 2008
Location: Mansfield, TX
Posts: 644
Likes: 0
Received 0 Likes
on
0 Posts
Jew, is that your car in the pic aka Brian? I got 255/40's but wondering depending how low I go if they're going to rub in the front wheel well when turning or not which rolling can't help. It looks close now with the stockies lowered so with a 255 I wonder if you had any issue with them. What height are you at from fender to ground on front and rear, or if you prefer, fender to wheel center?
up front i had a problem with it rubbing on the pinch weld that holds the inner fender structure together. and on the clear corners but other than that no issues.
i got it to stop rubbing on the pinch weld by grinding it down and having a buddy of mine run a new weld over then end on it which i think might have made it stronger anyways because they use spot welds from the factoy
ill measure from the top of the fender to the ground in a little bit but if i remember right i set it to 25.75 inches when i had my old tires but ill double check