19x9.5 & 19x10.5 +22 all around
19x9.5 & 19x10.5 +22 all around
Wondering on the fitment for these. I plan on running these with f)245/35/19 r)275/30/19. FYI my fenders are rolled already. I previously had 19x8.5 & 19x9.5 but my offset was + 35 and plus 38 and the car was lowered enough where the gap is basically flushed, or no tire gap.
Thanks guys!
Thanks guys!
and there is an entire thread dedicated to answering this very question...............................

edit: saw post #1...offset of +35 and/or +38. you're going an inch wider in rim size, and pushing them out 12 to 15 mm, so, yeah, it would be tight.
if tilt is suggesting a difficult situation, i would follow that, he's fit some retarded wide/low offset wheels on his rx8. other than that im my opion go for it! thats the exact fitment i want to try so you can be the test guinea pig!! i hope fender rolling and a little neg camber will do the trick. and it wont pop the sidemarkers out :'(
I'm already gona call this. PULL = 150% yes required I don't give a **** how much camber you run.
Camber department you are probably looking at -3.5* at least if you plan to run that big of a tire
Camber department you are probably looking at -3.5* at least if you plan to run that big of a tire
So did you end up getting it to fit with the 19x9.5 & 19x10.5 set up??? Reason I ask is I'm thinking of getting a set of 18X9.5 for the front and 19X10 for the back...offset i'm not sure yet...gotta get ahold of the seller. They are enkei RPF1 fyi.
Thread
Thread Starter
Forum
Replies
Last Post
ray_7
Series I Wheels, Tires, Brakes & Suspension
66
Jul 9, 2006 09:20 PM
donald121
Series I Wheels, Tires, Brakes & Suspension
8
May 13, 2006 04:44 PM
success07
Series I Wheels, Tires, Brakes & Suspension
4
Mar 13, 2005 05:02 PM




