Is it possible to replace these LED/Blub ?
#1
Is it possible to replace these LED/Blub ?
See the picture, one of the heater standby light is dead. I want to replace it, but cant find the part.
Anybody know if its even replaceable ? Or the Part Number ?
Thanks
Anybody know if its even replaceable ? Or the Part Number ?
Thanks
Last edited by nycgps; 11-15-2006 at 11:05 PM.
#3
Metatron
iTrader: (1)
Go for it......
Yank it out and take it to bits!
.....you have nothing to lose.
Pry up inside the cupholder to lift the back of the shifter surround, then pull straight up to lift it off. Disconnect the wires, then squeeze the tabs to free the switch - pretty straighforward after that, you either fix it or buy a new one.
S
.....you have nothing to lose.
Pry up inside the cupholder to lift the back of the shifter surround, then pull straight up to lift it off. Disconnect the wires, then squeeze the tabs to free the switch - pretty straighforward after that, you either fix it or buy a new one.
S
Thread
Thread Starter
Forum
Replies
Last Post
LMURailsplitter02
New Member Forum
1
09-06-2015 10:56 PM