mjd628

so today i installed a Agency Power lightened pulley and belts, after install i got a blinking check engine light indicating a random misfire which then turned into a solid p301 code which is cylinder 1 misfire. did anyone run into this problem also or have any idea what it is?

Jon316G

iTrader: (1)

Yes... common "problem" after installing a pulley... search a little bit.
Reset the NVRAM (eshaft profile).

mjd628

how do u reset the nvram (eshaft profile)

Jon316G

iTrader: (1)

Maybe you missed the part where I quoted, "search a little bit".
Since I'm in a generous mood... I did the search for you:
https://www.rx8club.com/showthread.p...ighlight=clear

mjd628

so simply pressing the brake 20 times within 8 sec resets this.... if so this sounds very simple.

Jon316G

iTrader: (1)

That's it...
Watching the oil pressure gauge needle sweep back and forth confirms it was done.

mjd628

ok thanks.... this was a big help