Having trouble passing evap monitor for emissions test
#1
Having trouble passing evap monitor for emissions test
I have been working on getting the rx8 ready for my smog check, being it is a obd2 vehicle the test now only consist of the monitors to be ready/passed. All of my monitors are ready except evap, I currently have no pending or hard fault codes, all factory evap equipment is hooked up. I'm assuming that no codes are present the system has not detected any leaks or faulty equipment. I have driven the car quite a bit with no luck. Does anyone know what the system is looking for to allow the monitor to pass? The shop manual does not provide a learning procedure. I have verified the purge solenoid clicks on and off if I add voltage to it.
I know for some manufacturers they can manually get the monitor to learn, can this be done with the 8?
Any help would be greatly appreciated
I know for some manufacturers they can manually get the monitor to learn, can this be done with the 8?
Any help would be greatly appreciated
Thread
Thread Starter
Forum
Replies
Last Post
br0wm
Canada For Sale/Wanted
5
10-24-2015 11:06 PM
pdxhak
General Automotive
7
09-22-2015 07:39 AM