Parking light install
#1
10K Redline
Thread Starter
Join Date: Jan 2009
Location: Fredericksburg, VA
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
Parking light install
Just bought the Xenon HID replacement bulbs for the parking lights to get rid of the stock yellowish color. Didn't read through ALL of the threads so this may have been answered already, but do I need to take off the bumper to get to those lights or can I do it without taking too much apart? Any help would be great.
#2
Registered
Join Date: Jun 2007
Location: Sheboygan Falls, Wisconsin
Posts: 1,134
Likes: 0
Received 1 Like
on
1 Post
I was wondering this too. The parking light on my drivers side is out but I'm not sure the best way to get at it.
I also had the passenger side fog light out, buy I found the DIY for that and it worked great.
Parking light I can't seem to find anything specific on here. It looks like it is accessible from the top but I'm not sure. I'm wondering if you can remove the fuse box to get at it?
I also had the passenger side fog light out, buy I found the DIY for that and it worked great.
Parking light I can't seem to find anything specific on here. It looks like it is accessible from the top but I'm not sure. I'm wondering if you can remove the fuse box to get at it?
#5
I recently changed my parking lights as well. I did not have to remove the bumper or the fender linings. The drivers side is relatively easy to change but it's still a tight squeeze to get your hand in there. The passenger side is even tighter but I used long needle nose pliers to turn the bulb socket and pull it out.
#9
Registered
iTrader: (7)
You need to learn how to search. https://www.rx8club.com/showthread.p...parking+lights
Things to remember while replacing these bulbs.
1. Make sure the bulb fits in the socket tight.
If not use a little electrical tape to hold it in. One wrap around will be fine, because if you use to much it will not fit back in the headlight housing.
2. Turn on your lights and make sure the bulb work before re-installing it.
Things to remember while replacing these bulbs.
1. Make sure the bulb fits in the socket tight.
If not use a little electrical tape to hold it in. One wrap around will be fine, because if you use to much it will not fit back in the headlight housing.
2. Turn on your lights and make sure the bulb work before re-installing it.
Last edited by invasion08; 02-03-2011 at 08:31 PM.
Thread
Thread Starter
Forum
Replies
Last Post
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM