cbmdj13b

I mean trailing plugs. Is that normal?

Bladecutter

Have you done a compression test on your rebuild as of yet?
If you didn't do the rebuild correctly, and still have low compression in the motor, that would be why you are having hot start issues.

Or, it could be something else (fuel pump, starter) causing the hot start issue.

BC.

cbmdj13b

took it out for a blitz. got a few air mass faults so ill give it a clean and see what happens. probably get a new one tomorrow. not done a compression test yet because you can tell its a lot better than before but ill get a kit tomorrow also and do that. I also think this is not an issue because it has problems starting from cold as well now. I have to give it a bit of throttle to get it going from cold and it floods when hot... Are fuel pumps a common issue as well?

cbmdj13b

Getting codes p0101 , p0103 , p0113 , p0300 , p0301 again. So a loads of maf and miss fire stuff.

cbmdj13b

New air mass but no difrences. Dose not start when it's hot or cold but starts perfect when warm. Need to give it a little throtel to start from cold but floods when it starts from cold. Please help......

cbmdj13b

Sorry .. Floods when it starts from hot.. Lamber sensor??

cbmdj13b

90 psi front and back rotors. . . . . . ????

shadycrew31

iTrader: (6)

you might have hard starts for a few hundred miles depending on the components you decided to reuse.

cbmdj13b

Is 90 psi ok? That's when it's hot and won't start. Is there a way I can test to coils? I think I mite have a duff set.

Fazil Malik

Hey Chris,

I need to know what exactly was the problem, did you find any solution?