Melted Plastic got on the bulb HELP
#1
EX-Member
Thread Starter
Join Date: Aug 2004
Location: Jacksonville FL
Posts: 1,286
Likes: 0
Received 0 Likes
on
0 Posts
Melted Plastic got on the bulb HELP
I was messing with the high beams and I sat it on something then next thing I knew melted plastic got on the bulb how do u get this off?
#3
I am the God of Hellfire!
Join Date: Apr 2005
Location: Philadelphia burbs
Posts: 146
Likes: 0
Received 0 Likes
on
0 Posts
Be careful, any scratch on the surface could cause the bulb to explode when it heats up. They run very hot. When you get it clean, make sure you wipe it off thoroughly with a soft cloth to remove any oils from your hands. A clean new steel razor blade should work to remove the plastic, since it is softer than the surface of the glass, apply light pressure and make sure there's no dirt or dust trapped beween the blade and the glass.
#5
Lubricious
Join Date: Oct 2003
Location: SF Bay Area, California
Posts: 3,425
Likes: 0
Received 4 Likes
on
4 Posts
I 2nd the new bulb recommendation. High-output halogen bulbs are pressurized and "explode" is not an exaggeration. The bulbs themselves are made out of fused quartz, not glass, to withstand the high temps. This works well, but once the quartz becomes contaminated it can weaken suddenly. Even touching a new bulb with your fingers can contaminate it enough to eventually lead to failure.
#8
X-Sapper
Join Date: Jan 2004
Location: where angle's fear to tread
Posts: 2,392
Likes: 0
Received 0 Likes
on
0 Posts
new bulb..anything on it can cause it to blow when it is on...just get a new on..and don't use your highbeams until you do.
(granted alchole will evaperate off of it..but why take teh chance of it blowing anyways...how much is a new bulb
(granted alchole will evaperate off of it..but why take teh chance of it blowing anyways...how much is a new bulb
Thread
Thread Starter
Forum
Replies
Last Post
projectr13b
Series I Do It Yourself Forum
1
09-06-2015 01:04 PM