Oil Return line leak?
02-12-2009, 06:15 AM
#1
Registered
Thread Starter
Oil Return line leak?
I was installing brake pads and decided to check the vac hose on my Greddy turbo set up. I noticed an oil stain on the floor and was really worried. The engine runs fine and never had any problems ever since I began using the Access Port. After further investigation I noticed the oil return line seemed to be a bit on the old side. (noticeable cracks) I guess it's from my last oil change.
My question is where can I go to replace this return line? Size and specifics would be greatly appreciated! A recommended upgrade would be nice too. BTW it's a simple leak and not spray from the oil restrictor (nos)
My question is where can I go to replace this return line? Size and specifics would be greatly appreciated! A recommended upgrade would be nice too. BTW it's a simple leak and not spray from the oil restrictor (nos)
Last edited by legendkurado; 02-12-2009 at 06:18 AM.
02-12-2009, 11:11 AM
#2
New oil return hose: http://www.atpturbo.com/Merchant2/me...egory_Code=OIL
You only need a foot (well, actually less, but they won't sell less than a foot).
You only need a foot (well, actually less, but they won't sell less than a foot).
Thread
Thread Starter
Forum
Replies
Last Post
Sifu
RX-8 Parts For Sale/Wanted
3
08-30-2015 10:51 PM
