Wiring front 2-way 6x8 speaker for base audio system
#1
Wiring front 2-way 6x8 speaker for base audio system
I have a set of 6x8 (2-way) Infinity Kappa speakers installed on the front of my 8. I have the base audio system. I am wondering if I need to disconnect the stock tweeters.
The Infinity's are 2 ohm and the stock tweeters are 4 ohm. I wonder if this will mess up the signal. The challenge I have is that I am not sure how the stock tweeter is wired. There is a pair of wires coming out from the HU, but there are 4 at the door (2x for woofer, 2x for tweeter).
Your advice would be much appreciated...
The Infinity's are 2 ohm and the stock tweeters are 4 ohm. I wonder if this will mess up the signal. The challenge I have is that I am not sure how the stock tweeter is wired. There is a pair of wires coming out from the HU, but there are 4 at the door (2x for woofer, 2x for tweeter).
Your advice would be much appreciated...
#2
Registered Lunatic
iTrader: (1)
If I remember correctly, the stock paper 6x8 speakers were also 4 Ohm, so replacing them with the 2 Ohm Kappas isn't a good idea. Disconnecting the tweeters will hardly help the situation.
There are quite a few people on here who might be able to come up with some solution - I don't have much audio expertise, sorry.
There are quite a few people on here who might be able to come up with some solution - I don't have much audio expertise, sorry.
Thread
Thread Starter
Forum
Replies
Last Post
rotarywanker
Series I Interior, Audio, and Electronics
3
12-08-2022 05:56 PM
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM