where did u input neutral switch w/ compustar?
11-07-2005, 09:38 AM
#1
where did u input neutral switch w/ compustar?
im going to put my compustar into automatic mode because its much more convenient (eg i can get somethign out of the car without having to reset reservation mode).. the only problem is that the compustar doesnt seem to have a neutral switch input (2w900fm),, if anyone installed their manual on a compustar system, please let me know what wire on the compustar you connected the neutral switch to.
11-07-2005, 10:07 AM
#2
if there isnt an input at all tell me how this sounds:
i do NOT bypass clutch with starter wire, instead i jsut connect the starter wire from remotestart to the wire @ ignition harness,
take neutral safety wire and input to pin 86 on relay,
fused 12v on 85.
87 is key side of starter wire @ clutch,
30 is starter side of starter wire @clutch.
87a unused.
this way, the clutch should only be bypassed when the car is in neutral correct? neutral= 87 connects to 30. in gear = relay open... unless im in the car and stomp on the clutch pedal.
i do NOT bypass clutch with starter wire, instead i jsut connect the starter wire from remotestart to the wire @ ignition harness,
take neutral safety wire and input to pin 86 on relay,
fused 12v on 85.
87 is key side of starter wire @ clutch,
30 is starter side of starter wire @clutch.
87a unused.
this way, the clutch should only be bypassed when the car is in neutral correct? neutral= 87 connects to 30. in gear = relay open... unless im in the car and stomp on the clutch pedal.
Thread
Thread Starter
Forum
Replies
Last Post
huhsler
Series I Interior, Audio, and Electronics
4
01-12-2004 11:04 AM
