I have a problem. I just recently purchased a factory NAV hood from a local memeber and I took it to a place to get a quote to get it installed.

On the back of the nav housing there are connections for the NAV and connections for the motorized screen part. The guy that I am trying to get this installed at, says he needs to know what each individual pin does what for the motorized connector. And I have no idea where to find that at..

I want to be able to install my touch screen inside the factory nav housing and have the motor work and the tilt and open buttons work.. Do any of you guys know how to do this at all?? I am in need for some help!

Thanks,

jb

 

The full electrical wiring is here:
http://www.hi-impact.org/ryang/modif...Electrical.pdf

I think only one member has his working properly, and he had to build another circuit to control everything. If your guy figures it out, let me know, I might have to drive down to the Natti. How much is he charging, if you don't mind me asking.

 

If you decide to go this route.

Schematics:
https://www.rx8club.com/showthread.p...light=nav+hood

 

Thanks for your help RA-Eight! They are charging me around $500-800.

Do you know which page the motorized portion of the wire diagram is in? All the guy wants is what the 6 little pins do in the back of the nav hood to make the thing motorized..

 

Sorry, I don't know where specifically. I haven't gone through that in a long time.