Notices

Heated Seat Problem...

Thread Tools
 
Rate Thread
 
Old Dec 3, 2009 | 12:59 PM
  #1  
kwikslvr's Avatar
Thread Starter
Rotary User
 
Joined: Jul 2008
Posts: 80
Likes: 0
From: Cincinnati, OH
Heated Seat Problem...

So i did a search and could not find any thread pertaining to my exact issue, so i am started a new thread.

I have an 04 GT with heated seats, well 1 heated seat, that's the problem. My passenger seat does actually get warm when the heaters are turned on, but my driver seat does not. With winter coming it would be nice to have my Butt Warmer up and running.

i would check the Fuse, but im assuming they would both be hooked to one.

Any Ideas?

Thanks ahead of time.
Reply
Old Dec 3, 2009 | 01:03 PM
  #2  
dozer's Avatar
on his 3rd rx8
iTrader: (3)
 
Joined: Dec 2006
Posts: 6,036
Likes: 12
From: santa ana, ca
check the connection to the buttons
Reply
Old Dec 3, 2009 | 01:05 PM
  #3  
mscamp02's Avatar
Blue Bullet?
iTrader: (3)
 
Joined: Dec 2008
Posts: 2,593
Likes: 1
From: morehead, Ky
Mine has had the same problem but I really dont use them so I havent bothered to check anything on it
Reply
Old Dec 3, 2009 | 01:06 PM
  #4  
kwikslvr's Avatar
Thread Starter
Rotary User
 
Joined: Jul 2008
Posts: 80
Likes: 0
From: Cincinnati, OH
The lights on both buttons come on, so it appears that everything is good there. i guess it may be the heater itself or the wires from the switch to the heater. if it is the heater, is that replaceable or not?
Reply
Old Dec 3, 2009 | 01:11 PM
  #5  
mscamp02's Avatar
Blue Bullet?
iTrader: (3)
 
Joined: Dec 2008
Posts: 2,593
Likes: 1
From: morehead, Ky
hmmm...you could try just switching the connectors around to determine if it is the seat or if it is the connectors. Because if the drivers seat gets warm with them switched then you know where the problem is....same thing in reverse.
Reply
Old Dec 3, 2009 | 01:12 PM
  #6  
DubbsLuvs8s's Avatar
Registered
iTrader: (1)
 
Joined: Jan 2009
Posts: 227
Likes: 0
From: Wantagh, Long Island
Mine does the same butt (hehehe) opposite. My seat gets warm, but the passenger doesn't seem to.

Dealership told me it was fine, I think they lied.

In all honesty, the passenger seat does do something, but it's not nearly as effective as my seat.
Reply
Old Dec 3, 2009 | 01:38 PM
  #7  
The Reverend's Avatar
That's a lie
iTrader: (1)
 
Joined: Jan 2009
Posts: 2,320
Likes: 1
From: I don't wear panties
Originally Posted by mscamp02
hmmm...you could try just switching the connectors around to determine if it is the seat or if it is the connectors. Because if the drivers seat gets warm with them switched then you know where the problem is....same thing in reverse.
The connectors are different colors, I am not sure they can be switched

Try looking under the seat as well.
Reply
Old Dec 3, 2009 | 04:15 PM
  #8  
mscamp02's Avatar
Blue Bullet?
iTrader: (3)
 
Joined: Dec 2008
Posts: 2,593
Likes: 1
From: morehead, Ky
yea ones black and ones tan but i think they were the same, cant remember cuz its been a while since ive been under there
Reply
Old Dec 4, 2009 | 09:21 AM
  #9  
kwikslvr's Avatar
Thread Starter
Rotary User
 
Joined: Jul 2008
Posts: 80
Likes: 0
From: Cincinnati, OH
yeah i didnt get a chance to look last night (was helping a friend put a new axle in his integra) but i'll look at it over the weekend.

Thanks for all the input.
Reply
Old Dec 4, 2009 | 10:17 AM
  #10  
mscamp02's Avatar
Blue Bullet?
iTrader: (3)
 
Joined: Dec 2008
Posts: 2,593
Likes: 1
From: morehead, Ky
put up a post if you get your seats working cuz apparently there are a lot of people with this issue
Reply
Old Dec 4, 2009 | 11:01 AM
  #11  
bmak's Avatar
Registered
iTrader: (4)
 
Joined: Apr 2008
Posts: 151
Likes: 0
From: Newark, DE
My seats are both working fine. IIRC, there is a difference in the seat design, one of the seats has heating elements in the bottom of the seat and in the lower back area of the seat, the other has only the bottom portion, not the lower back. If you're thinking that one doesn't work, make sure that this isn't what you are experiencing.
Reply
Old Dec 10, 2009 | 07:19 PM
  #12  
merkidemis's Avatar
Registered User
 
Joined: May 2009
Posts: 30
Likes: 0
I am currently having this issue as well. My driver's side seat doesn't work, even though the light on the switch comes on. I'll try the swap thing tomorrow or Saturday, as it is really numbingly cold outside right now.
Reply
Old Dec 26, 2009 | 06:18 PM
  #13  
elysium19's Avatar
Registered
iTrader: (1)
 
Joined: May 2005
Posts: 1,410
Likes: 2
From: Long Island, NY.
any insights? having the same problems.

and there are TWO "seat warm" fuses in the fuse box!! one big, one small, anyone know the difference???
Reply
Old Dec 29, 2009 | 08:38 AM
  #14  
robbz23's Avatar
Registered
 
Joined: May 2004
Posts: 140
Likes: 0
From: Norrköping, Sweden
I have the same issue here and let me tell u it is freaking cold here in sweden. So i pulled up the diagram and i checked everything from the switches to the connector under the seat. When I disconnected the connector and checked the resistance on the circuit for the heater it appears that there is a short some where in the seat. I tried the same on the passenger side that was working but had a hard time seeing and it got really cold so I came back inside. Oh and yes mine is a normal US car imported to sweden.
Attached Thumbnails Heated Seat Problem...-seats.jpg  
Reply
Old Dec 31, 2009 | 08:26 PM
  #15  
greenarixate77's Avatar
Registered User
 
Joined: Oct 2009
Posts: 7
Likes: 0
From: Chester, VA
I have the same problem as well. The driver's side switch seemed to light up when turned on; but no heat comes up.

I disconected both driver's and passenger's heat warmer switch - they cannot be switched around to tell if one of them is not working because the end fitting for both assemblies are different.

My fuse seemed to be fine. I'm not sure what the issue would be.
Reply
Old Jan 5, 2010 | 01:49 PM
  #16  
otakurx's Avatar
Rotorheaded Geek
 
Joined: Oct 2006
Posts: 517
Likes: 0
From: Manchester,NH
I have developed this same issue. I've assumed it is the wiring in the seat itself since it seems to have coincided with the airbag warning light coming on. I have found wiggling the wires makes everything work again at least for a little while. I plan on digging into it this coming weekend as well as my power steering wiring.
Reply
Old Jan 5, 2010 | 01:53 PM
  #17  
robbz23's Avatar
Registered
 
Joined: May 2004
Posts: 140
Likes: 0
From: Norrköping, Sweden
Looks like I found the solution for mine today, a wire inside the seat cover had been completely clipped. I will post some pics and troubleshooting techniques later.


@otakurx -- Yours definitely sounds like the main connector under the seat is loose some how. If the airbag warning light is going off. I had the same issue on my passenger side and it went away when i reseated the connector
Reply
Old Jan 6, 2010 | 10:01 PM
  #18  
greenarixate77's Avatar
Registered User
 
Joined: Oct 2009
Posts: 7
Likes: 0
From: Chester, VA
robbz23, did you have to take the seat out of the car to find this out? Was the connector attached to the bottom cushion?
Reply
Old Jan 7, 2010 | 12:19 AM
  #19  
robbz23's Avatar
Registered
 
Joined: May 2004
Posts: 140
Likes: 0
From: Norrköping, Sweden
Yes -- I took the seat out and removed the cushion. The line going up to bottom seat cushion was broken. I have some pics that will help and I will try to post them today.
Reply
Old Jan 7, 2010 | 01:42 AM
  #20  
robbz23's Avatar
Registered
 
Joined: May 2004
Posts: 140
Likes: 0
From: Norrköping, Sweden
Hey guys I wrote it up as a DIY with pics from my fix and shots from the repair manual that should help.

https://www.rx8club.com/showthread.php?p=3378725

Last edited by robbz23; Jan 7, 2010 at 01:57 AM.
Reply
Old Jan 9, 2010 | 04:58 PM
  #21  
greenarixate77's Avatar
Registered User
 
Joined: Oct 2009
Posts: 7
Likes: 0
From: Chester, VA
Thank you so much, Rob. You the man!
Reply
Old Jan 12, 2010 | 11:14 PM
  #22  
TBAGG's Avatar
Registered
 
Joined: Jul 2009
Posts: 45
Likes: 0
Hey - just so you know I had the 'Power Steering' light come on and the power steering not working. But it was intermittent. I took the car to dealer and he was like "yeah... we cleaned the connector... it works now... no big deal" ... so if you are still having this issue just remember to 'Clean Your Connector' instead of 'Wiggle Wires'

Originally Posted by otakurx
I have developed this same issue. I've assumed it is the wiring in the seat itself since it seems to have coincided with the airbag warning light coming on. I have found wiggling the wires makes everything work again at least for a little while. I plan on digging into it this coming weekend as well as my power steering wiring.
Reply
Old Aug 30, 2013 | 08:59 PM
  #23  
vukovi's Avatar
Registered
 
Joined: May 2012
Posts: 20
Likes: 0
From: Louisiana
link broken

Hi, I have an issue with my seats, and I am pretty sure they were clipped by the previous owner for some strange reason. However, the link above does not work. It just loads a blank page. Could someone check on that?? Or just repost the pics here?
Reply
Old Aug 30, 2013 | 09:00 PM
  #24  
vukovi's Avatar
Registered
 
Joined: May 2012
Posts: 20
Likes: 0
From: Louisiana
ummm ok it works... maybe I had to be signed in?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
fourwhls
RX-8's For Sale/Wanted
7
Feb 20, 2019 05:16 PM
jasonrxeight
RX-8's For Sale/Wanted
2
Sep 30, 2015 01:53 PM
alming1132
RX-8 Parts For Sale/Wanted
0
Sep 30, 2015 11:30 AM
XianUnix
Series I Trouble Shooting
6
Sep 29, 2015 03:48 PM
DeltaJ802
RX-8 Discussion
3
Sep 29, 2015 01:20 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -5. The time now is 07:22 PM.