Footwell - Ash Tray Light Tap
#1
Registered
Thread Starter
Join Date: Sep 2009
Location: San Jose, CA
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Footwell - Ash Tray Light Tap
Hello CLUB!
I'm trying to do my own footwells & I wanted to do something similar to what Aipex8 did which was to do this DIY
( https://www.rx8club.com/series-i-do-yourself-forum-73/diy-footwell-lights-179213/page2/ ) & go the extra mile & tap into the ash tray light for a different set of LEDs. I've searched around & even flipped through the electrical book for the RX8, but I can't seem the figure out what colored wires I'm supposed to tap into!
Thanks in advance!
I'm trying to do my own footwells & I wanted to do something similar to what Aipex8 did which was to do this DIY
( https://www.rx8club.com/series-i-do-yourself-forum-73/diy-footwell-lights-179213/page2/ ) & go the extra mile & tap into the ash tray light for a different set of LEDs. I've searched around & even flipped through the electrical book for the RX8, but I can't seem the figure out what colored wires I'm supposed to tap into!
Thanks in advance!
#3
Registered
Thread Starter
Join Date: Sep 2009
Location: San Jose, CA
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
it looks like there are about 4 wires but I can only see three colors from the drivers side:
- Blue w/ red stripes
- Blue w/ light green stripes
- Black w/ white stripe
- A black wire (not sure if there's stripe)
Thread
Thread Starter
Forum
Replies
Last Post
JimmyBlack
Series I Major Horsepower Upgrades
273
02-10-2020 10:23 PM