lurch519

well, finally broke down and bought the alpine iva-d310 and put it in this weekend. the wiring was very straight forward, even with the bose amp. the difficult part was mounting the head unit itself.

below you will see pics of my first attempt. i basically molded a new housing in the factory nav screen location. once i was done molding, i primed and painted the piece black.

im not entirely satisfied with the end result, but as its my first attempt, i cant say its too bad.

dont mind the mess on the dash piece, i havent had a chance to fully clean it up yet.

NgoRX8

iTrader: (1)

Good first attempt. Have any pics of the whole center unit?

lurch519

no, i dont, im gonna be getting another center module and redoing this one, molding the piece completely and painting the whole unit to match the factory radio

TRU681

Looks good so far, nice job!

army_rx8

sweet can't wait to see the finished product

robbz23

lurch -- Did you buy a nav center dash panel for a non-Navi? How much was it? I am going to attempt to do something similar soon for my VGA motorized touchscreen. It basically looks exactly the same as the Pioneer, but I won't need access to the buttons under the screen. We will see how it goes.

lurch519

nope, thats my factory nav dash piece. im going to see about getting another one, and fully molding the original one in.

robbz23

so that means you took out the factory nav? any chance you want to sell the screen bezel and hinge piece?

Japan8

Dude... any chances that the entire original dash assembly is still in your possession and works (flip open and close motor and buttons)?