Defi Gauge wiring question - RX8Club.com

Notices

Defi Gauge wiring question

Old 06-18-2018, 05:09 PM
  #1  
Registered
Thread Starter
 
Join Date: Dec 2005
Location: B.C.
Posts: 36
Thanks: 0
Thanked 0 Times in 0 Posts
Defi Gauge wiring question

Already installed my Defi BF gauges and controller but in regards to the wiring is there anything closer near the kick panel/fuse that I can use for the white wire aka Illumination? I know most go to cigarette light but I'm hoping to have something closer. Thank you
olyrx7 is offline  
Old 07-05-2018, 10:54 AM
  #2  
Registered
 
Join Date: Oct 2016
Location: Hampton, VA
Posts: 13
Thanks: 0
Thanked 0 Times in 0 Posts
I came across this info from another post. I'll be installing my Defi gauges sometime in August, so I can't yet verify if this works.

Kick panel wires:
12 Volt (+) 12ga. White/Red in driver’s door harness at driver’s kick panel or 12ga Orange just above kick panel

Ignition 1 18ga. Black/Yellow at driver’s kick panel (will be in same harness as door trigger)

Accessory 1 12ga. Green/Yellow (R.A.P.) in driver’s door harness at driver’s kick panel

Starter 18ga. White/Blue left of steering column in small White connector

Horn 18ga. Green/Orange (-) left of steering column in large White connector

Lights (+) 18ga. Red/Yellow left of steering column in large White connector

Lights (-) 18ga. Orange (flashes hazards) at flasher under left side of dash above trunk release button

Door 1 18ga. Black/Blue (-) at driver’s kick panel

Interior Lights Same as door trigger

Trunk/Hatch 18ga. Brown (-) at passenger’s kick panel

Hood Pin 18ga. Violet/White (-) (N.C. use relay) above driver’s kick panel in smaller group of wires that lead into main harness going through firewall

Trunk Release 18ga. Yellow (-) at trunk release button on bottom left side of dash

Lock (switch) 18ga. Lt. Green (-) @ 1000 ohm in driver’s door harness at driver’s kick panel

Unlock (switch) Same wire (-) @ 0 ohm

Disarm (key) 18ga. Green/Red (-) @ 0 ohm in driver’s door harness (extended pulse will unlock all doors)

Arm Input 14ga. Red/Blue (M) in driver’s door harness or at keyless entry module behind passenger’s kick panel

Disarm Input 1 14ga. Red/Black (M) at same

Disarm Input 2 14ga. Green (M) at passenger’s kick panel in door harness or at keyless entry module
brownmd is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Interpol
Series I Interior, Audio, and Electronics
0
06-04-2008 06:03 PM
joon
Series I Trouble Shooting
5
01-08-2006 11:00 AM
Naughty Boy
RX-8 Multimedia/Photo Gallery
2
02-21-2005 09:38 PM
StealthTL
Series I Interior, Audio, and Electronics
1
01-04-2005 03:45 AM
Need For Speed
Series I Interior, Audio, and Electronics
14
11-04-2003 02:51 PM


Thread Tools
Search this Thread
Rate This Thread
Rate This Thread:
You have already rated this thread Rating: Thread Rating: 0 votes,  average.

Quick Reply: Defi Gauge wiring question


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.