Defi Gauge wiring question
Already installed my Defi BF gauges and controller but in regards to the wiring is there anything closer near the kick panel/fuse that I can use for the white wire aka Illumination? I know most go to cigarette light but I'm hoping to have something closer. Thank you
|
I came across this info from another post. I'll be installing my Defi gauges sometime in August, so I can't yet verify if this works.
Kick panel wires: 12 Volt (+) 12ga. White/Red in driver’s door harness at driver’s kick panel or 12ga Orange just above kick panel Ignition 1 18ga. Black/Yellow at driver’s kick panel (will be in same harness as door trigger) Accessory 1 12ga. Green/Yellow (R.A.P.) in driver’s door harness at driver’s kick panel Starter 18ga. White/Blue left of steering column in small White connector Horn 18ga. Green/Orange (-) left of steering column in large White connector Lights (+) 18ga. Red/Yellow left of steering column in large White connector Lights (-) 18ga. Orange (flashes hazards) at flasher under left side of dash above trunk release button Door 1 18ga. Black/Blue (-) at driver’s kick panel Interior Lights Same as door trigger Trunk/Hatch 18ga. Brown (-) at passenger’s kick panel Hood Pin 18ga. Violet/White (-) (N.C. use relay) above driver’s kick panel in smaller group of wires that lead into main harness going through firewall Trunk Release 18ga. Yellow (-) at trunk release button on bottom left side of dash Lock (switch) 18ga. Lt. Green (-) @ 1000 ohm in driver’s door harness at driver’s kick panel Unlock (switch) Same wire (-) @ 0 ohm Disarm (key) 18ga. Green/Red (-) @ 0 ohm in driver’s door harness (extended pulse will unlock all doors) Arm Input 14ga. Red/Blue (M) in driver’s door harness or at keyless entry module behind passenger’s kick panel Disarm Input 1 14ga. Red/Black (M) at same Disarm Input 2 14ga. Green (M) at passenger’s kick panel in door harness or at keyless entry module |
All times are GMT -5. The time now is 10:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands