yenphi

I just got basslink II and I think it is bigger than basslink I, because it would not sit properly at the back of the trunk like some pictures I saw here. So who has the II and where you put this. Pictures would be nice, thanks a lot in advance.
Now I have done the system and with pictures w/ attached link, thanks

bruce_van

Hmm....I was considering the Basslink II eventually. Let us know how it goes.

yenphi

I eventually put it in the trunk by myself and be honest it is sound very good, much better than before, I also add 2 polk tweeters in front next to the bose tweeter, and also a component in the back beween back seats because I have bass link insert which pop out 4 -35watts channel.

BRODA

iTrader: (7)

Yenphi, Do you have a picture of where you installed the sub? Also, did you wire the front speakers into the 4SC or just the rears?

Thanks,
Dave

yenphi

the sub is at the conner of the rectangular in the back trunk where the jack is located. the 4 channel: 2 of them I fed the stock rear bose, 2 I fed 2 new speakers between back seats, hum i did not take picture yet but if time allow i will later.

yenphi

i just take some pic but dont know how to post

bruce_van

Let's see some pictures. You can add the JPEG as an attachment. PM me for an email address if you can't figure it out. I'd really like to see how it turned out.

rx8phase1

iTrader: (1)

i had the same problem it was too big to lay down so i screwed it standing up

momo

Create an account on photobucket or tinypics, it's free.

yenphi

Hi, here they are:http://s217.photobucket.com/albums/cc59/yenphirx8/
What do you guys think?

BRODA

iTrader: (7)

Looks good. Did you use self-tapping screws to bolt the sub to the floor?

yenphi

Iuse 1 inch screw to nail the sub down, no problem

bruce_van

Here you go:







Looks good.