amp installation with bose stereo
#1
Guest
Posts: n/a
amp installation with bose stereo
i've been doin some reading and have completed my sub/amp installtion all accept for the rca's running into the amp.
do i just tap the set of rca's directly to the rear speaker wires before they enter the bose amp? and than run them to the amp that is powering the sub? or do i need a line converter for this?
just a bit confused is all
thanks in advance.
do i just tap the set of rca's directly to the rear speaker wires before they enter the bose amp? and than run them to the amp that is powering the sub? or do i need a line converter for this?
just a bit confused is all
thanks in advance.
#4
ಠ_ಠ
Join Date: Aug 2007
Location: Under the Dumbarton Bridge
Posts: 2,228
Likes: 0
Received 6 Likes
on
5 Posts
it would work For about a day until you fried the output stage of your head unit i suppose. I had better luck with a JL cleansweep then I did my Audiocontrol LC7. But once you get a LOC in and replace all the speakers you're going to want an EQ. Any device that taps into the signal lines before the Bose amp in the trunk of the car needs to be able to handle a low level, differential signal, and that means a LOC for the most part.
Last edited by Socket7; 09-22-2008 at 10:01 AM.
Thread
Thread Starter
Forum
Replies
Last Post
yurcivicsux
Series I Major Horsepower Upgrades
192
09-12-2017 10:54 PM
garethleeds
Europe For Sale/Wanted
6
11-19-2015 06:32 AM
AMOC
SE RX-8 Forum
1
09-09-2015 05:14 AM