Removing Dealer Logos
02-02-2010, 12:07 PM
#26
Registered User
Join Date: Feb 2010
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
How to Remove the Dealer Decal
3-Steps to Remove the Dealer Logo:
1. Heat up the badge with a hair dryer. This makes the double-sided foam loosen up.
2. Use dental floss to cut it. Tip: Go very slow, back and forth as if the floss is a saw. As you create the ’saw’ motion, pull the floss away from the car so it rubs against the badge and not the car. Feel free to alternate between heating the badge again and then resume flossing. Don’t worry if the floss breaks, just heat the badge and begin where where you left off.
3. After the logo comes off, clean it up with microfiber chamois and WD-40.
1. Heat up the badge with a hair dryer. This makes the double-sided foam loosen up.
2. Use dental floss to cut it. Tip: Go very slow, back and forth as if the floss is a saw. As you create the ’saw’ motion, pull the floss away from the car so it rubs against the badge and not the car. Feel free to alternate between heating the badge again and then resume flossing. Don’t worry if the floss breaks, just heat the badge and begin where where you left off.
3. After the logo comes off, clean it up with microfiber chamois and WD-40.
Thread
Thread Starter
Forum
Replies
Last Post
Racingjunkie
Series I Wheels, Tires, Brakes & Suspension
2
09-29-2015 05:05 PM
Learners_Permit
Series I Interior, Audio, and Electronics
8
09-27-2015 07:38 PM
