magma simoni racing
#1
Registered User
Thread Starter
Join Date: Aug 2007
Location: ZH, Switzerland
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
magma simoni racing
hi everybody
just got a little question... is it possible to install this part with 102mm diameter?
http://www.autoboxsnc.com/ecommerce-id-5008.html
but i don't have this plates: http://accessories.mazdausa.com/wcss...austFnsher.jpg
regards
chnielsen
just got a little question... is it possible to install this part with 102mm diameter?
http://www.autoboxsnc.com/ecommerce-id-5008.html
but i don't have this plates: http://accessories.mazdausa.com/wcss...austFnsher.jpg
regards
chnielsen
#2
Surf Hard, Drive Hard
Join Date: Feb 2007
Location: Indialantic, Florida
Posts: 7,840
Likes: 0
Received 11 Likes
on
9 Posts
hi everybody
just got a little question... is it possible to install this part with 102mm diameter?
http://www.autoboxsnc.com/ecommerce-id-5008.html
but i don't have this plates: http://accessories.mazdausa.com/wcss...austFnsher.jpg
regards
chnielsen
just got a little question... is it possible to install this part with 102mm diameter?
http://www.autoboxsnc.com/ecommerce-id-5008.html
but i don't have this plates: http://accessories.mazdausa.com/wcss...austFnsher.jpg
regards
chnielsen
#3
Registered RX8 Nut
iTrader: (11)
If you have a 4" tip like the racing beat exhaust, you should get the exhaust finishers. The first time I ran my car hard for about 15 min straight, I got melted plastic all over my exhaust tips. Check out mazdatrix, i think they had the best price and the shipped them right away. http://www.mazdatrix.com/8exterior1.htm
#8
Registered User
Thread Starter
Join Date: Aug 2007
Location: ZH, Switzerland
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
thx for all your replies. now I'm wondering how to remove the original mazda tip? any screenshots or manual or something like this?
thx again!
thx again!
Thread
Thread Starter
Forum
Replies
Last Post
RAVSPEC
Vendor Classifieds
0
10-01-2015 01:59 PM