Air Dam Install
#1
Pettit fangurl <3
Thread Starter
Join Date: Mar 2005
Location: Aston, PA
Posts: 5,386
Likes: 0
Received 0 Likes
on
0 Posts
Air Dam Install
I just received my air dam yesterday and Im looking over the instructions...its says that you have to take the front bumper off to install it....is that the case? as anyone installed it without taking it off?
thanks for any input in advance..
thanks for any input in advance..
#2
May Cause Anal Leakage
Join Date: Oct 2004
Location: Orlando & Chicago
Posts: 3,191
Likes: 0
Received 0 Likes
on
0 Posts
I had two put on mine at the dealer.First one was defective,and both times they had to remove the bumper. It's really not that difficult. Check the DIY on bumper removal.
#3
Registered
iTrader: (1)
Join Date: May 2003
Location: PA
Posts: 3,754
Likes: 0
Received 0 Likes
on
0 Posts
Yup, you have to take the bumper off. Once you get it off, you have to strip the bumper of the factory black piece, then locate little crosshairs on the back of the bumper to drill 6 (i think) holes through it.
Just remember that if you have foglights to remember to disconnect them... that step wasn't exactly in the instructions
Just remember that if you have foglights to remember to disconnect them... that step wasn't exactly in the instructions
#4
Storm Trooper
Join Date: May 2004
Location: Freakmont, CA
Posts: 3,908
Likes: 0
Received 0 Likes
on
0 Posts
Its really not that hard, but if you are afraid to drill your car, I suggest you get some help, or let the dealer do it. Shouldn't take more than 2 hours if you're taking your time.
Thread
Thread Starter
Forum
Replies
Last Post
LMURailsplitter02
New Member Forum
1
09-06-2015 10:56 PM
Rupanrx
Series I Aftermarket Performance Modifications
1
09-04-2015 06:44 AM
akagc
RX-8's For Sale/Wanted
7
08-11-2015 07:07 PM