Need Help setting up my boost controller!
Thread Starter
Booost.
iTrader: (1)
Joined: Nov 2006
Posts: 1,099
Likes: 1
From: Markham/Richmond Hill/Toronto
Need Help setting up my boost controller!
I guess I posted in the wrong place before...
hopefully I'll get some help in this section..
I just installed the Greddy E-01...
It seems pretty to use when I read some threads on here suggesting on how to set-up the controller
Current setup
LO:
Set: 50%
Gain: 0
Start boost: 5.2
Baseline WITHOUT contoller on is around 5PSI
So now I should be netting 7.5 PSI correct?
Ilde without AC: ~-7.0 to ~-7.5 PSI
IDLE with A/C: ~-7.5 to ~-8.2 PSI
Coasting in-gear: -11PSI
ok..so am I on the right track?
I am getting a fluttering sound...sounds like a valve opening and closing really fast.
and My limiter is OFF.
whats wrong.
next...I NEED this to monitor
Where can I tap into the RPM signal coming from the ECU.
the E-01 askes for that when installed to log my RPM/Boost.
hopefully I'll get some help in this section..
I just installed the Greddy E-01...
It seems pretty to use when I read some threads on here suggesting on how to set-up the controller
Current setup
LO:
Set: 50%
Gain: 0
Start boost: 5.2
Baseline WITHOUT contoller on is around 5PSI
So now I should be netting 7.5 PSI correct?
Ilde without AC: ~-7.0 to ~-7.5 PSI
IDLE with A/C: ~-7.5 to ~-8.2 PSI
Coasting in-gear: -11PSI
ok..so am I on the right track?
I am getting a fluttering sound...sounds like a valve opening and closing really fast.
and My limiter is OFF.
whats wrong.
next...I NEED this to monitor
Where can I tap into the RPM signal coming from the ECU.
the E-01 askes for that when installed to log my RPM/Boost.
Last edited by TurboEight; Jul 20, 2008 at 12:06 AM.
Thread
Thread Starter
Forum
Replies
Last Post