RX8 Friend - Latest Map?
#1
Registered User
Thread Starter
Join Date: Jan 2004
Location: Austin Tx (Leander)
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
RX8 Friend - Latest Map?
I understand you wrote something about the latest map being done as of 5/18/04 so a 1.1 unit that was purchased say 4/15/04 would you say is not ready for the M Flash? And if it is not what do I need to do to get it up to spec? Do I send it to you? And what would the cost be? Just checking before I attempt to put this in because I get the M flash on Wednesday and do not want to run into any problems with the car not wanting the M Flash with the Canzoomer. Thanks
#2
Registered User
Thread Starter
Join Date: Jan 2004
Location: Austin Tx (Leander)
Posts: 290
Likes: 0
Received 0 Likes
on
0 Posts
Sorry did not read the previous post about updates and such. So I need the software and cable but I really do not have access to a laptop and nor do I want to buy one. So what then?
#3
Registered User
Join Date: Jul 2003
Location: Edmonton
Posts: 680
Likes: 0
Received 0 Likes
on
0 Posts
You could program it with a desk top computer. We can make a power cable for it. You will need a 12 V DC power supply - about 2 Amps and regulated voltage. The power cable would cost around $10, the power supply (Radio Shack) perhaps $30. Less than shipping after a couple of map changes. You can get a programming cable for a USB port or a 9 pin RS-232 port if you don't have USB.
I think the previous maps work with "M", the current one is just optimized for it. Try it and see.
You can send it back to us - we update them free, you pay shipping. Shipping is not cheap!
I think the previous maps work with "M", the current one is just optimized for it. Try it and see.
You can send it back to us - we update them free, you pay shipping. Shipping is not cheap!
Thread
Thread Starter
Forum
Replies
Last Post
Touge
Canada Forum
0
08-11-2015 10:19 PM